Deficient frame and redundant frame - truss, Mechanical Engineering

Assignment Help:

Deficient Frame and Redundant Frame - truss:

Deficient Frame:

If the numbers of member in the frame are less than (2j-3), then the frame is called as deficient frame.

Redundant Frame:

If the numbers of member in frame are more than (2j-3), then the frame is called as redundant frame.

 


Related Discussions:- Deficient frame and redundant frame - truss

Compute the maximum bending moment, Compute the maximum bending moment: ...

Compute the maximum bending moment: A simply supported beam of 7 m length carries point loads 2 kN, 4 kN and 6 kN at distances of 1 m, 2 m & 4 m from the fixed end respectivel

Wire melting characteristics, WIRE MELTING CHARACTERISTICS A non linear r...

WIRE MELTING CHARACTERISTICS A non linear relationship exists between the rate at which the wire is fed into the arc and the current required to burn it off to maintain a constan

What is precipitation, Q. What is Precipitation? Precipitation includes...

Q. What is Precipitation? Precipitation includes rain, snow and hail. The maximum, average, and storm volumes will have an impact on the size and positioning of facilities to c

Evaluate the chebyshev spacing for a function, Evaluate the chebyshev Spaci...

Evaluate the chebyshev Spacing for a function y = 2 x 2 - x for the range 0 ≤ x ≤ 2 where four precision point are required. For these precision points, determine φ 2 , φ 3 , φ 4

Illustrate clay content test, Q. Illustrate Clay content test? Under th...

Q. Illustrate Clay content test? Under this test, the clay content is measured by washing it off the sand sample. The standard dried sand sample (50 gm) is put in a mixing devi

Open belt drive, Open belt drive: An open belt drive connects the two...

Open belt drive: An open belt drive connects the two pulleys 120cm and 50cm diameter on parallel shafts which are apart 4m. The maximum tension in belt is 1855.3N. Coefficien

Design loading - unloading facilities in plant layout, Q. Design Loading - ...

Q. Design Loading - Unloading Facilities in plant layout? Loading and unloading areas should be separated. These facilities should be situated on the edge of the site near road

Stress analysis requirements, Q. Stress analysis requirements? All othe...

Q. Stress analysis requirements? All other lines requiring review by the stress group are to be checked for adequate support, stability, excessive movement, etc. Where hand ca

Beam along the centreline, Determine the vertical de?ection in the beam alo...

Determine the vertical de?ection in the beam along the centreline and state the maximum de?ection.

Equivalent force f - mechanics, If Equivalent force F and F acting on rigid...

If Equivalent force F and F acting on rigid body are not in line Sol.: If equivalent force of same magnitude 'F' acting on the rigid body are not in line, then there is no c

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd