Can you explain corners and fillets, Mechanical Engineering

Assignment Help:

Q. Can you explain Corners and fillets ?

Corners and fillets

The intersection of the surfaces in casting must be smooth and forms no sharp angles. For this, the external and intern corners of patterns are suitably rounded. They are called round corners and fillets respectively.

Rapping or shake allowance

To take pattern out of the mould cavity it is slightly rapped to detach it from the mould cavity. Due to this, the cavity in the mould increases slightly so the pattern is made slightly smaller.


Related Discussions:- Can you explain corners and fillets

Plasma welding, PLASMA WELDING This is an extension of TIG welding. In...

PLASMA WELDING This is an extension of TIG welding. In plasma welding torch, plasma energy is constricated and ensures its most efficient utilisation for welding cutting and s

What is thermoplastic plastics, Q. What is thermoplastic plastics ? Thes...

Q. What is thermoplastic plastics ? These plastic soften under heat, harden on cooling, and can be resoften under heat. Thus, they retain their fusibility, solubility, an

Calculations for the force to move a block, Calculations for the force to m...

Calculations for the force to move a block: T wo blocks A and B having weight 4KN and 2KN respectively are in equilibrium position as shown in the figure given below. Coeffi

Evaluate resultant of the system - mechanics, Evaluate resultant of the sys...

Evaluate resultant of the system: Q: Figure given below shows two vertical forces and couple of moment 2000 Nm acts on horizontal rod, which is fixed at end A .  Determin

Define verband der automobilindustries flachenschnittstelle, Verband der Au...

Verband der Automobilindustries Flachenschnittstelle (VDAFS) This interface was developed by the Association of the German Automobile Industry for the transfer of 3-D curves an

Open and closed thermodynamic system, Steam flowing at a rate of 3200 lbm/h...

Steam flowing at a rate of 3200 lbm/hr enters an adiabatic nozzle. The initial condition of steam is: P1 = 250 psi, v1=620 ft/min, v1 = 2.4 ft3/lbm and u1 = 1125.5 Btu/lbm. The ste

Hydropower scheme, 4. Design a run-of-the river hydropower scheme for a riv...

4. Design a run-of-the river hydropower scheme for a river in the Scottish Borders with potential level different of 15 m carrying water from a catchment area of 14 km by 25 km. I

What is a coated tool, (a) What is a coated tool? What are its advantages? ...

(a) What is a coated tool? What are its advantages? What types of coatings are used in cutting tool. Discuss. (b) Discuss different types of cutting fluids, their properties and

What is shallow foundation, What is Shallow foundation Shallow foundati...

What is Shallow foundation Shallow foundations are those where the depth D

Find out the deflection - vertical, Find out the deflection: Find out ...

Find out the deflection: Find out the deflection (vertical) at a distance 'a' from the tip in Example Solution As in this case there is no load at the point where the

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd