Battery inspection steps, Mechanical Engineering

Assignment Help:

Battery Inspection :  A fully charged and properly maintained battery is essential for proper lighting and starting of the motorcycle.

STEPS

  • Remove the right side cover and inspect the battery.
  • Remove the battery and observe that the electrolyte should be between the 'MAX' and 'MIN' mark given on the battery.
  • If the level is below the 'MIN' mark it should be topped up to the 'MAX' level with distilled water.
  • Check the specific gravity of the battery fluid. Specific gravity is checked with the help of HYDROMETER in each cell of the battery.
  • The specific gravity should be between 1.24 - 1.27.
  • Battery is inspected for voltage by the help of a battery tester or a Multimeter.
  • If the battery is undercharged it should be charged by a battery charger with a charging current of 0.25 A.

 


Related Discussions:- Battery inspection steps

What are preheat and interpass temperature, Q. What are Preheat and interpa...

Q. What are Preheat and interpass temperature? Preheat and interpass temperatures shall be in accordance with the applicable codes. Materials that require preheat for welding

Net angle of twist at the free end - steel shaft, Net angle of twist at the...

Net angle of twist at the free end - steel shaft:  The stepped steel shaft illustrated in Figure is subjected to a torque (T) at the free end and a torque (2T) in the opposite

Sequecing problm, What is the sequence of this problem Job- 1 2 3 4 5 6 7 ...

What is the sequence of this problem Job- 1 2 3 4 5 6 7 M/c M1 4 13 16 7 11 12 10 M2 9 11 11 7 13 2 4

Slipping of belt, the effect of slip of belt on the pulleys on the velocity...

the effect of slip of belt on the pulleys on the velocity ratio of belt drive?

Determine the displacement response time, (i) Formulate the equation of mot...

(i) Formulate the equation of motion for the system shown in Figure. List TWO (2) assumptions made in this formulation. (ii) Find the response of this system at t = 3s. The syst

Determine the width and depth of the beam, Determine the width and depth of...

Determine the width and depth of the beam: A timber beam of rectangular section is only supported over a span of 5 m. It carries an uniformly distributed load of 15 kN/m over

Use of trusses, Use of trusses: Where do you find trusses in use? ...

Use of trusses: Where do you find trusses in use? The main uses of truss are as follows: 1. The trusses are used to support slopping roofs. 2. Brick trusses are

Represent moment graphically - mechanics, Represent moment Graphically: ...

Represent moment Graphically: How you represent moment Graphically? Sol.: Consider force F which is represented in magnitude and direction, by   line AB . L

Explain construction and working of rope brake dynamometer, Explain constru...

Explain construction and working of Rope Brake Dynamometer? Determine Power also ?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd