Functions of geometric modeling, Mechanical Engineering

Assignment Help:

Q. Functions of geometric modeling?

Design Analysis

• Evaluation of area, volume, mass and inertia properties.

• Interference checking in assemblies.

• Analysis of tolerance build-up in assemblies.

• Kinematic analysis of mechanisms and robots.

• Automatic mesh generation for finite element analysis.


Related Discussions:- Functions of geometric modeling

Grease gun--tool and equipment , Grease Gun: A grease gun is shown in Figu...

Grease Gun: A grease gun is shown in Figure. This is used to supply semi-solid lubricant (grease) for chassis lubrication. Figure : Grease Gun

Illustrate the specification of pddi, Illustrate the specification of PDDI ...

Illustrate the specification of PDDI (i)  The 3-D geometry of the product which is defined by a set of curves, surfaces and volumes. (ii) The topology which describes the se

Low lube oil pressure security in API612 , What type of low lube oil securi...

What type of low lube oil security recommended for API612 steam turbines.(Electronic/Mechanical). Please give refrences

Illustrate the general shear failure in bearing capacity, Illustrate the ge...

Illustrate the general shear failure in bearing capacity. General Shear Failure: In this case of failure, contiguous failure surfaces develop between the edges of the footin

Thermodaynamic, Ask question #MiThe steam that leaves the super-heater is e...

Ask question #MiThe steam that leaves the super-heater is expanded from 130bar at 535°C to 25.2bar at 310°C in a high pressure turbine. The steam from the exit of the HP turbine is

What is a machine shop, A facility that uses machines to fabricate devices ...

A facility that uses machines to fabricate devices from stock raw materials or to change mechanisms based upon given specifications. Also, know as "Back" Shops. The common machi

Mechanical properties of materials, A tensile test on a specimen having an ...

A tensile test on a specimen having an initial diameter of 13.11 mm and an initial gauge length of 200.0 mm, gave the following data:

Determine the actual absolute velocity, Question: As shown in the figur...

Question: As shown in the figure, the jet transport B is flying north with a velocity v B = 600 km/h when a smaller aircraft A passes underneath the transport headed in the 60

Explain corner joint, Corner joint- The flush corner joint is designed prim...

Corner joint- The flush corner joint is designed primarily for welding sheet metal that is 12 gauge or thinner. It is restricted to lighter materials. The half-open corner join

Explain about hydraulic calculation, Hydraulic calculations are carried out...

Hydraulic calculations are carried out by both Process and Mechanical Engineering. Generally speaking, Process Engineering will initiate many hydraulic calculations for piping sys

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd