Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Q. Production Test Rings?
The frequency for the tests shall be as follows:
• One sample at the 10th joint
• One sample at the 75th joint
• One sample at the 300th joint
• One sample at the 500th joint and every 400th joint thereafter unless the application temperature or some other major procedure is changed.
This will require the removal of 1.5' (0.5 m) of pipe from the appropriate joint and shall be obtained at least 1' (0.3 m) from a pipe end. The Applicator will restencil any identification eliminated through the removal of this pipe on to the pipe joint at no expense to the OWNER.
The cylindrical tank with hemispherical ends shown in Fig. have volatile liquid and its vapor. The liquid density is 800 kg/m3, and its vapor density is negligible. The pressure in
A flat belt, 8 mm thick and 100 mm wide transmits power between two pulleys, running at 1600 m/min. The mass of the belt is 0.9 kg/m length. The angle of lap in the smaller pulle
The open square tube is subjected to the torque T= DEF Nm as shown in Fig Q2. The tube has the length 1m and wall thickness 5mm. a) Calculate the shear stress and angle of
Variables used in WPS Depending on their influence on obtaining a desired weldment, the welding variables are then classified and listed. Some of them are listed as "Essential
Calculate thermal efficiency and compression: Q: Calculate thermal efficiency and compression ratio for automobile working on otto cycle. If energy generated per cycle is t
Q. Corrosion Control in Oil-Treating Equipment? Bitumen provides adequate internal protection for Inlet Slug Catcher, FWKO and Treater. Due to high operating temperature, inter
Shear Stress Distribution of T section
Gas Porosity Porosity is the presence of gas pockets or voids caused by the entrapment of gas evolved during weld metal solidification. This Porosity is caused due to im
an engine having
Problem: The following machine component is loaded as shown. It is fabricated from Al 6061-T6. Determine the analytical solution to this problem and compare result
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +91-977-207-8620
Phone: +91-977-207-8620
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd