Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1.A 100-ft steel tape was used to measure a partial baselinedistance. The rear surveyor held 47 ft, while the head surveyorheld .62 ft. What is the distance measured?
2.Using Fy=50ksi, select the lightest available section for the spanand loading shown. Consider moment and shear only and neglect beamweight in all calculations. The member is assumed to have fulllateral bracing.
The beam is simply supported with two sets of loads each 2 ftfrom the reactions.
So there's a live load of 150k and a dead load of 80k 2ft from theleft reaction and 2ft from the right reaction. The total span is16ft... So the distance between the to pair of loads is 12ft..
Determine the minimum necessary clearance height of the overpass and the resultant elevation of the bottom of the overpass over the PVI. (ignore the cross-sectional width of the overpass)
A young engineer has invented holographic mobile phones and has approached a venture capital company to invest in it. The venture capital company considers the product to be an all or nothing product
An earthquake with a magnitude 6.5 on the Richter scale is producing a ground displacement of 50 mm at a particular location and the energy released by the earthquake is "E".
Two strips of a plastics material are bonded together as shown. The average shearing stress in the glue must be limited to 1000 kpa.
Estimate how much carbon (in pounds) must be purcahsed for a typical 2-bed carbon adsorption system to treat 5000 cfm of air at 95 degrees F and 1 atm. The air contains 600 ppm of styrene.
three different materials designated a b and c are tested in tension using test specimens having diameters of 0.755 in.
Estimate the energy required to raise the temperature of 2 kg (4.42 lbm) of the following materials from 20°C to 100°C (68°F to 212°F): aluminum, steel, soda-lime glass, and high-density polyethylene.
How many 3:4-inch diameter rivets are required to transmit 55,000 lb from the two angles to the gusset plate if the allowable shear stress in the rivets is 15,000 psi Assume each rivet carries the same amount of load.
Lake Pleasant, AZ, has a surface area of approximately 2,000 ha. The inflow for the month of August is zero. The lake is dammed so that no water leaves the impoundment downstream of the dam. There is no rain in August.
What is the concentration of NH3 (in mg/L) of household ammonia that contains 3.00 percent by wieght of NH3. Assume the density of water = 1000kg/m^3
During an experiment, the depth of a water flow in a flume is measured five times by using a ruler with 1/16-in division. The results from these measurements are 4.88 in, 5.06 in, 5.03 in, 5.13 in, 4.94 in. What is the instrumental error and what ..
Find the swell for a soil which weighs 1600kg/m in bank and 1300kg/m3 in bank and 1300kg/m3 Loose and what is the shrinkage factor for a mass of soil that takes up 1.5m3 in bank and reduces down to 1.2m3 after compaction
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd