What will be the grade elevation at station

Assignment Help Civil Engineering
Reference no: EM13534532

1.The grade elevation at station 25+00 is to be 946.52 ft. What will be the grade elevation at station 34+86.20 if the grade linerises at the rate of 1.785% between these two points?

2.An unknown distance was stepped off four times, requiring 306, 308,307, and 305 paces. Determine the length of the line.

3.A lake has 115 miles long and a surface area 225 square miles. Ifduring flood condition flows into the lake is 45000 cfs and outflow8000 cfs, how many feet per 24-hr day will the lake level rise?

Reference no: EM13534532

Questions Cloud

How much must the temperature of the ring be increased : A steel ring of internal radius 499.8 mm is to be shrink-fitat normal (room) temperature over a rigid cylinder of radium r =500 mm
The horizontal distance between the point : The elevtion of M is 875 . a transit was set at point M and a leveling rod was held vertically at point N. the horizontal cross line of the telescope was inclined so the reading of the horizontal cross line
How are you to tell what the reynols number is : A rectangular concrete channel 4m wide on a slope of 0.002 is designed to carry water(T = 10 C) at discharge rate 25m^3/s. Estimate the uniform flow depth for these conditions?
How do you find this answer : A 14in diameter pipe pile is driven 50ft into a dry loose sandwhose unit weight is 105 pcf. The angle of internal frictionis 33 degrees. Compute the safe axial downward loading
What will be the grade elevation at station : The grade elevation at station 25+00 is to be 946.52 ft. What will be the grade elevation at station 34+86.20 if the grade linerises at the rate of 1.785% between these two points?
Find the percentage of aceticacid ionized in the solution : One liter of a solution is made by adding 3grams of acetic acid (HAc) to distilled water. The molecular weightof acetic acid is 60.052. The acid dissociation constant for aceticacid
Determine the pressure at a stagnation point on that stream : At a given point on a horizontal streamline in flowing air, thestatic pressure is -2 psi (ie vacuum) and velocity is 150 ft/s.Determine the pressure at a stagnation point on thatstreamline?
What would be the concentration : What is the aqueous phase CO2 concentration (mg/L) of a watersample that is not in equilibrium with the atmosphere and has a pH= 7.1, an alkalinity of 300 mg/L and a temperature of 25 degrees C?
While the head surveyorheld .62 ft. what is the distance : Using Fy=50ksi, select the lightest available section for the spanand loading shown. Consider moment and shear only and neglect beamweight in all calculations. The member is assumed to have fulllateral bracing.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Find what is the tracks radius of curvature at the instant

A race car C is being tracked via telemetry. The on-board acclerometer records and acceleration level of -.7get+.5gen. If you know that the v at this instant is 200km/hr, what is the tracks radius of curvature at this instant

  Find e and deflections at points

Find e1, e2, e3 and deflections at those points

  Determine what percent of particle are retained in clarifier

if the settling velocity of a particle is 2.8 mm/s and the overflow rate of an upflow clarifier is .56 cm/s what percent of the particles are retained in the clarifier

  Concept of strengthening mechanisms

Describe in your own words the three strengthening mechanisms i.e., grain size reduction, solid solution strengthening, and strain hardening. Be sure to explain how dislocations are involved in each of the strengthening techniques.

  Determine stresses acting on an element oriented at angle

Using the stress transformation equations only,given a stress state where sigma x=105 MPa,sigma y=75 MPa and tau xy=25 MPa, determine the stresses acting on an element oriented at an angle 40 degrees from the x axis.

  Determine the bending moment at the intermediate support

The left-hand span is 16 ft and the right-hand span is 20 ft. The beam supports a uniform load of 900 plf, which includes its own weight, over the entire 36 ft and also a concentrated load of 10,000 lb applied at a point that is 5 ft from the left..

  What is the dry unit weight of this material

A soil borrow material in its natural state in the ground has a unit weight of 118pcf. Its natural water content is 7%. What is the dry unit weight of this material?

  Determine the velocity of the boat after man have both dived

A 180 lb man and a 120 lb woman stand at opposite ends of a 300 lb boat, ready to dive, each with a 16 ft/s velocity relative to the boat. Determine the velocity of the boat after they have both dived

  Find the horsepower added for the flow through the system

Find the horsepower added if the flow through the system is 400 m^3/s. The entrace is sharp, the two bends are equivalent to smooth 90 degree bends with R=1 ft, and there are two fully open gate valves

  Determine how much money the homeowner would have saved

If t his house were heated instead by a heat pump that has an average COP of 2.4, determine how much money the homeowner would have saved that month. Assume the price of electric power is $0.085 per kW - hr.

  Find the load bearing strength of a support beam

Looking a wood (pine) deck material.  It's a simple 8' by 8' deck.  There's a support beam holding up this deck. Other end is connected to building.

  Determine tension in each cable and reaction at socket joint

A 10 ft. boom is acted upon by the 840-lb force. Determine the tension in each cable and the reactionat the ball-and-socket joint at A.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd