How do you find this answer

Assignment Help Civil Engineering
Reference no: EM13534533

A 14in diameter pipe pile is driven 50ft into a dry loose sandwhose unit weight is 105 pcf. The angle of internal frictionis 33 degrees. Compute the safe axial downward loading, usingthe effective stree β-method for the statical analysis. Applya factor of safty of 2.75. ANSWER: Q(design)=142kN. How do you find this answer?

Reference no: EM13534533

Questions Cloud

Determine the prism constant : A 100 ft cut steel tape was used to check the layout of a building wall. the rear surveyor held 42 ft while the head surveyor cut 0.33 ft. what is the distance measured?
How much must the temperature of the ring be increased : A steel ring of internal radius 499.8 mm is to be shrink-fitat normal (room) temperature over a rigid cylinder of radium r =500 mm
The horizontal distance between the point : The elevtion of M is 875 . a transit was set at point M and a leveling rod was held vertically at point N. the horizontal cross line of the telescope was inclined so the reading of the horizontal cross line
How are you to tell what the reynols number is : A rectangular concrete channel 4m wide on a slope of 0.002 is designed to carry water(T = 10 C) at discharge rate 25m^3/s. Estimate the uniform flow depth for these conditions?
How do you find this answer : A 14in diameter pipe pile is driven 50ft into a dry loose sandwhose unit weight is 105 pcf. The angle of internal frictionis 33 degrees. Compute the safe axial downward loading
What will be the grade elevation at station : The grade elevation at station 25+00 is to be 946.52 ft. What will be the grade elevation at station 34+86.20 if the grade linerises at the rate of 1.785% between these two points?
Find the percentage of aceticacid ionized in the solution : One liter of a solution is made by adding 3grams of acetic acid (HAc) to distilled water. The molecular weightof acetic acid is 60.052. The acid dissociation constant for aceticacid
Determine the pressure at a stagnation point on that stream : At a given point on a horizontal streamline in flowing air, thestatic pressure is -2 psi (ie vacuum) and velocity is 150 ft/s.Determine the pressure at a stagnation point on thatstreamline?
What would be the concentration : What is the aqueous phase CO2 concentration (mg/L) of a watersample that is not in equilibrium with the atmosphere and has a pH= 7.1, an alkalinity of 300 mg/L and a temperature of 25 degrees C?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Find the maximum bending stresses wood and steel

Find the maximum bending stresses(wood) and (steel), in the wood and steel, respectively, due to the uniform load if the modulus of elasticity are E (wood)=10 GPa for the wood and E (s)=210 GPa for the steel.

  How to draw and label a flowchart for the system

The temperature of steam at the inlets of both turbines is 500 C, and the enthalpy of steam is 3027 kJ/kg at the exit of high pressure turbine, and 2385 kJ/kg at the exti of the low pressure turbine.

  What is present worth of five years of cost of maintanance

you purchased an old machine at the beginning of this year.maintanance on this old machine will be 100$ at the end of this year but is expected to increase by $25 each year after. what is the present worth of five years of the cost of maintanance

  What is the empirical formula of aluminum oxide

{rm Al} reacts with 4.45 {rm g} of {rm O}_{2}, what is the empirical formula of aluminum oxide?

  How far apart in nautical miles are ships at the time

ship A leaves port sailing in a direction 60 degree C north of due east and sails for 12 hours at 10 knot . Sheep B leaves the same port 3 hours later and sails due east at 25 knot for 9 hours.

  Specify and construct the foundations for the new building

The subsoil at the site is a thick layer of soft alluvial river silts and sands, the bearing capacity of the silt has been found to be in the region of 80 kN/m2. There is a high ground water table present.

  Probelm relating to fire a bullet

A bullet is fired from a height of 150m at a velocity of 300kmph at an angle of 35 upward. Neglecting air resistance. Find: a) total time of flight b) horizontal range

  Calculate the flow rate from the lake and into the aquifer

A geological fault truncates the aquifer at a distance "L" upstream from the river. The hydraulic conductivity of the area between the fault and the river is 50 ft / day and hydraulic conductivity between the lake and the fault is 100 ft / day.

  Calculate what ground distance will be measured

What ground distance will be measured if grid distance is 2158m and Orthometric height = 850m, Scale factor Sf = 0.9999943, Geoidal separation N = 27m, Ra = 6371km

  How to calculate the surface tension of the liquid

Two capillary tubes have radii of 1 mm and 0.5 mm respectively. They are placed in a liquid whose density is 0.80 g/cc and which completely wets the walls of the tube, i.e. theta = 0. The difference in height of capillary rise is 0.74 cm.

  Calculate as many principal or maximum strains

The direct strain at an angle of 30o,to one of theprincipal axes was 1.34x10-3 and the corresponding shearstrain was 8.52x10-4. Calculate as many principal or maximum strains at the point

  Estimate contact time to achieve an effluent concentration

Estimate the contact time to achieve an effluent concentration of 200 fecal coliforms/100 mL using a Cl2 dose of 3 mg/L if the wastewater temperature is 28 oC. Assume the activation energy (Ea) at pH = 7.4 is 6,500 cal/mole.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd