When will the queue clear

Assignment Help Civil Engineering
Reference no: EM13210620

There are 10 vehicles in a queue when an attendant opens a toll booth. Vehicles arrive at the booth at a rate of 4 per minute. The attendant opens the booth and improves the service rate over time following the function u(t) = 1.1 + .30t, where u(t) is in vehicles per minute and t is in minutes. When will the queue clear?

Reference no: EM13210620

Questions Cloud

What types of attacks can still occur : Do the administrators of server systems still have to be concerned about, and take further countermeasures against DoS attacks, if so, what types of attacks can still occur, and what measures can be taken to reduce their impact?
What will be the total vehicle delay : Assuming D/D/1 queuing, what will be the total vehicle delay?
What is the probability that the vehicle pulling out : what is the probability that the vehicle pulling out will get in an accident with oncoming traffic?
What type of exercise takes place in a classroom : What type of exercise takes place in a classroom setting arranged to look like an emergency operations center or in an actual emergency operations center, and involves simulation using written, telephone, and radio messaging.
When will the queue clear : where u(t) is in vehicles per minute and t is in minutes. When will the queue clear?
Explain whats the anode charge : whats the anode charge. please include the answer and why and a step process please
Compute normal and critical depths in a concrete culvert : compute normal and critical depths in a concrete culvert(n=0.015)with a diameter of 36in.and a bed slope of 0.002ft/ft if the design discharge is 15cfs.is the slope steep or mild?reap for S= 0.02ft/ft.
What type of contract would you want and why : If you were asked to perform an excavation contract competitively with limited data, what type of contract would you want and why?
Type of project communication : What type of project communication should Janet implement to discuss the status, technical issues and responsibilities on the project?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculating coefficient of permeability

The temperature was 200C, and the void ratio (e) of the soil was 0.43. Calculate the "Coefficient of Permeability" in "centimeters per second" (Given, k = (QL)÷(A Δh t)).

  Presedimentation-uspended solids concentration of raw revers

Presedimentation can reduce the suspended solids concentration of raw river water from 500 mg/L to 200 mg/L. How many pounds of dry solids does this represent per million gallons?

  Pulling automobile by means of two ropes

A disabled automobile is pulled by means of two ropes as shown. The tension in AB is 400 lb and the angle is 20. knowing that the resultant of the resultant of the two forces applied at A is directed along the axis of the automobile, determine by ..

  Calculate the detention time

As a consulting engineer you are hired to evaluate the operation and the unit processes within the plant and make recommendations for improvements. You are asked to consider the following units.

  Engineering societies based on the research

What are Engineering Societies based upon the research? List at least 10 discipline specific engineering societies along with their website addresses.

  Introduction to consolidation settlements

Include immediate and consolidation settlements, but ignore secondary compression. In your calculation, use three sublayers with thicknesses of 4 ft, 8 ft and 16 ft for the top, middle and bottom layers. Ignore any settlement caused by the dense s..

  Calculating the force in a punch press

Calculate the force (in Kn) a punch press must exert if it is to punch out a large washer from a strip of 5-mm thick sheet steel with an ultimate shear strength of 400 MPa.

  What would the new value of hc be

If the fracture were planar in shape, having an average opening of 2 mm, what would the new value of Hc be?

  Determining the velocity of motor having constant power

A constant power of 1.5 hp is supplied to the motor while it operates with an efficiency of ε = 0.8. Determine the velocity of the 200-lb crate in 15 seconds, starting from rest. Neglect friction.

  Darcy-weisbach equation for flow in a pressure conduit

In using the Darcy-Weisbach equation for flow in a pressure conduit, what percentage error is introduced in Q when f is misjudged by 20 percent?

  Write a paper on steel sustainability

Write a paper on steel sustainability.

  Define water circulating through it at the rate

A 4 X 8-ft solar collector has water circulating through it at the rate of 1.0 gallon per minute while exposed to sunlight with intensity 300 Btu/ft^2-hr.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd