What would side slope of cut be if catch point is located

Reference no: EM13309831

A backsight reading of 2.56 was obtained with rod at A and a foresight reading of 7.45 was obtained with the rod at the trial point B. If B is located 37.00 feet from the center line of a planned 50-foot wide road, is the catch point located uphill or downhill from B? What would
the side slope of the cut be if the catch point is located at B? Given: Elevation of A is 251.20 feet. Road bed is to be at the 240.0 foot elevation with 2:1 side slopes.

Reference no: EM13309831

Questions Cloud

Elements that might be presented in a balanced scorecard : Define the elements that might be presented in a balanced scorecard and explain how it is used - Make a recommendation of whether or not EEC should adopt the balanced scorecard

Determine reverse-saturation current of the pn junction : Find the voltage v0 and current i0 of the diode circuit shown in the figure below. You may assume a diode cut-in voltage of vy = 0.7V - difference in forward-bias voltages between the two diodes is 0.3V. Determine the reverse-saturation current of t..

Determine the hydraulic conductivity of the sand in field : In the field, if the relative compaction is 90%, determine the hydraulic conductivity of the sand in the field compaction condition (given that k for the sand at the maximum dry density condition is .040 cm/sec and Gs = 2.65).

What is the nominal strength with one end fixed : The length is 10 feet. What is the nominal strength if Fy=50 ksi. Note that this is a slender-element compression member, and the equations of AISC section E7 must be used

What would side slope of cut be if catch point is located : A backsight reading of 2.56 was obtained with rod at A and a foresight reading of 7.45 was obtained with the rod at the trial point B. If B is located 37.00 feet from the center line of a planned 50-foot wide road, is the catch point located uphi..

Determine the acre-feet of water that can be impounded : An earth fill is constructed across a drainage. Closed contours at the 1000, 1040 and 1080 foot levels define areas of 680,000; 1,200,000; and 1,325,000 square feet respectively.

Obtain the net torque on the wheel : A Ferris wheel accelerates from rest to an angular speed of 1.5 rad s-1 in 12 s. what is the net torque on the wheel

Determine the the max weight of the block : Determine the the max weight of the block that the system does not fail if the max tension that can be developed in cable DB is 100N and the max compression that can be developed in tower CD is 100N.

Compute the rms voltage across the secondary : A 12 DC power supply is connected to the primary coil of a transformer. What is the rms voltage across the secondary

User Account

All Pages