What will be the porosity of the mixture

Assignment Help Civil Engineering
Reference no: EM13555146

You are furnished with three sizes of particles. One is gravel with porosity of 0.32, the second is a coarse grained sand with porosity of 0.37, and the third is a fine grained sand with porosity of 0.23. If the coarse grained sand will fill the voids left by the gravel, and the fine grained sand will fill the void left by the coarse grained sand,

(a) What bulk volumes of gravel, coarse grained sand, and fine grained sand will be required to make a packing with a bulk volume of 1ft^3?

(b) What will be the porosity of the mixture?

Reference no: EM13555146

Questions Cloud

What should be the concentration of pollutant : A lagoon with volume 1,200 m3 has been receiving a steady flow of a conservative waste at a rate of 100 m3/day for a long enough time to assume that steady-state conditions apply. The waste entering the lagoon has a concentration of 10 mg/L. assuming..
With what velocity will air enter the room under : Laboratories containing dangerous materials are often kept at a pressure slightly less than ambient pressure so that contaminants can be discharged through an exhaust system rather than leaked through cracks and around doors to other parts of the bui..
What concentration of ozone should be injected : Ozone is sometime used as a disinfectant for drinking water. Ozone is highly reactive it will react benign species found in water, as well as the pathogens it is intended to kill.
Determine the percentage increase in the discharge : As part of a drainage improvement project, a drainage ditch will be straightened and cleaned. As a result, the lenght of the ditch will decrease from 1800 ft to 1400 ft and the mannings roughness factor will be reduced
What will be the porosity of the mixture : You are furnished with three sizes of particles. One is gravel with porosity of 0.32, the second is a coarse grained sand with porosity of 0.37, and the third is a fine grained sand with porosity of 0.23. If the coarse grained sand
Determine redox state of sulfur in both the compounds : Derive the porosity values for cubic, orthorhombic, and rhombohedral packing of spheres. Include sketches supporting your calculations of the bulk volumes of the unit cells.
Calculate the plasticity index the liquidity index : The soil is under a rectangular concrete slab 15m x 50m, used as a foundation for a building. A water pipe, in diameter id located in a trench 450mm below the center of the slab. The trench running along the length of the slab,300mm wide and 450mm de..
Will johnsons actions have any implications for future : In this case, it seems clear why Johnson is tempted to omit references to the ambiguous data. He is understandably anxious to graduate and move on to other challenges in his professional life. He is worried that full disclosure of his findings could ..
Determine the volume and density of the body : The volume and the average density of an irregularly shaped body are to be determined by using a spring scale. The body weighs 7200 N in air and 4790N in water. Determine the volume and density of the body. State your assumptions.

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the isentropic efficiency of the compressor

An adiabatic argon unit compresses argon at 200 kPa and 27C to 2.18 MPa. If the Argon leaves this compressor at 513C. What is the isentropic efficiency of the compressor

  Estimate the storage change for the lake during the month

A lake with a surface area of 1050 acres was monitored over a period of time. During a one month period, the inflow was 33 cfs, the outflow was 27 cfs, and a 1.5 in seepage loss was measured.

  What is the probability that at least one of the averages

A process is normally distributed and in control, with known mean and variance, and the usual three-sigma limits are used on ?? control chart, so that the probability of a single point plotting outside the control limits when the process is in contro..

  Determine the level of service for the segment

Determine: a. the Level of Service for this segment; b. the loss in Level of Service, if due to construction the lane width is reduced to 10 feet and there are concrete barriers one foot away from either end of the pavement.

  Determine the components of the reaction at point c when the

The object ABC consists of two slender rods welded together at point B. Rod AB has a mass of 1 kg and bar BC has a mass of 2 kg. Knowing the magnitude of the angular velocity of ABC

  What is the vertical shear stress distribution at each point

For a narrow horizontal rectangular beam of width b and depth h (cross section), determine a) what is the vertical shear stress distribution (tau)xy at each point y along the cross section,

  Determine the amount of garbage produced in the city in each

A city with 28,000 percent population is planning solid waste program. Population growth in the city is estimated to be 2.2% annually and the planning will designed for 30 years

  Find that the average man in our sample weighs 180 pounds

Suppose we want to estimate the average weight of adult males in greater metropolitan Atlanta area. We draw a random sample of 1,000 men from a population of 1,000,000 men and weigh them.

  Determine at which of the two points the elevation is higher

At point 2, the velocity and pressure are 14 ft/s and 23 psi. Determine at which of these two points the elevation is higher. Calculate the height difference. (Assume the sp ecific gravity of butane is 0.6 and that the butane is at a temperature o..

  Determine maximum value of z if flow is to remain laminar

The slope of the hill is such that for each mile (5280 ft) of horizontal distance, the change in elevation is Δz. Determine the maximum value of Δz if the flow is to remain laminar and the pressure all along the pipe is constant.

  What is the terminal velocity of the ping pong ball in water

A ping-pong ball (diameter = 40mm, weight= .03 N Volume =4piR^3/3) is released from the bottom of a swimming pool. What is the terminal velocity of the ping pong ball in the water

  Derive equations for the shear force and the bending moment

(a) Derive equations for the shear force V and the bending moment M for segments: AB, AC and AD (Place the origin at point A). (b) Plot the shear-force and bending-moment diagrams for the beam using the derived functions.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd