Determine the percentage increase in the discharge

Assignment Help Civil Engineering
Reference no: EM13555147

As part of a drainage improvement project, a drainage ditch will be straightened and cleaned. As a result, the lenght of the ditch will decrease from 1800 ft to 1400 ft and the mannings roughness factor will be reduced to 0.018 from 0.022. Determine the percentage increase in the discharge the ditch can accomodate at the same normal depth.

Reference no: EM13555147

Questions Cloud

What must be the allowable elongation : A cylindrical rod of brass alloy (E = 100 GPa,) having a yield strength of 345 MPa is to be subjected to a load of 7500 N. If the length and diameter of the rod are 338 mm and 7.55 mm respectively, what must be the allowable elongation?
What should be the concentration of pollutant : A lagoon with volume 1,200 m3 has been receiving a steady flow of a conservative waste at a rate of 100 m3/day for a long enough time to assume that steady-state conditions apply. The waste entering the lagoon has a concentration of 10 mg/L. assuming..
With what velocity will air enter the room under : Laboratories containing dangerous materials are often kept at a pressure slightly less than ambient pressure so that contaminants can be discharged through an exhaust system rather than leaked through cracks and around doors to other parts of the bui..
What concentration of ozone should be injected : Ozone is sometime used as a disinfectant for drinking water. Ozone is highly reactive it will react benign species found in water, as well as the pathogens it is intended to kill.
Determine the percentage increase in the discharge : As part of a drainage improvement project, a drainage ditch will be straightened and cleaned. As a result, the lenght of the ditch will decrease from 1800 ft to 1400 ft and the mannings roughness factor will be reduced
What will be the porosity of the mixture : You are furnished with three sizes of particles. One is gravel with porosity of 0.32, the second is a coarse grained sand with porosity of 0.37, and the third is a fine grained sand with porosity of 0.23. If the coarse grained sand
Determine redox state of sulfur in both the compounds : Derive the porosity values for cubic, orthorhombic, and rhombohedral packing of spheres. Include sketches supporting your calculations of the bulk volumes of the unit cells.
Calculate the plasticity index the liquidity index : The soil is under a rectangular concrete slab 15m x 50m, used as a foundation for a building. A water pipe, in diameter id located in a trench 450mm below the center of the slab. The trench running along the length of the slab,300mm wide and 450mm de..
Will johnsons actions have any implications for future : In this case, it seems clear why Johnson is tempted to omit references to the ambiguous data. He is understandably anxious to graduate and move on to other challenges in his professional life. He is worried that full disclosure of his findings could ..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine what does the e stand for on roads

E on roads extending east and west and S on roads extending north and south.Those roads traveling east and west are designated a number and the letter E.

  What is the stress along the top edge and the bottom edge

A horizontal pre-stressing force of 500kN is applied to rectangler beam. the beam has a depth of 500mm and a width of 250mm. the force is applied at a distance of 80mm below the x-x axis.

  Determine the diameter and the depth of the tank

A drinking water treatment plant will be designed to process a flow of 15,000 m3/d. The sedimentation tank will have a residence (detention) time of 4 hours and the overflow rate (Q/A) of 16 m3/m2-day

  Find what is the pressure on the soil if theta is 45 degrees

A pipe is to be installed under the ground on a bed of aggregate 6 in. thick. The entire weight on the aggregate from pipe and soil above the pipe is 1800 lbs. per linear foot of pipe. What is the pressure on the soil if theta is 45 degrees

  Design simple horizontal curve to connect roadway tangents

Design a simple horizontal curve to connect two roadway tangents that deflect at an angle chosen between 50 and 75 degrees. Assign a station to the curve PI and select a curvature of 6 degrees.

  Estimate the required volume of the aeration tank

A town is going to upgrade its primary WWTP to a secondary plant that can meet the effluent standard of 25 mg/L BOD5 and 30 mg/L suspended solids. They have selected a CSTR activated sludge system for the upgrade.

  Determine the height of the weir for discharge coefficient

This weir is to be replaced by an uncontracted horizontal weir that will maintain the same upstream depth. Determine the height of the weir if the discharge coefficient is based on the following equation: C = 1.78 * 0.22(H/p)

  Find an equation of a plane containing the three points

Find an equation of a plane containing the three points (-2, 5, -3), (-7, 3, 1), (-7, 4, 3) in which the coefficient of x is -8.

  Find the minimum downstream do that could be expected

For the following waste and river characteristics just upstream from the outfall, find the minimum downstream DO that could be expected

  Determine what is the total force on the roof at collapse

a storage tank has a diameter of 80 ft, a height of 25ft and contains oil to a height of 15ft. the suction pumps, which can handle 15000bbl/d, are started, but the safety valves are clogged and a vacuum is drawn in the tank.

  How many cubic yards of aggregate must be ordered for a road

How many cubic yards of aggregate must be ordered for a road base 16 inches thick and 2000 feet long with a top width of 30 ft, if the side slopes are one on one, or 45 degree?

  Determine what should the viscosity of the model fluid be

In the late 1990's the U.S. Army Corps of Engineers designed an experiment to model the flow of the Tennessee river downstream of the Kentucky Lock and Dam.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd