What is the runoff rate into the inlet grate

Assignment Help Civil Engineering
Reference no: EM13210556

A paved parking lot section has a uniform slope over a length of 100 m (in the flow direction) from the point of a drainage area divide to the inlet grate, which extends across the lot width of 30 m. Rainfall is occurring at a uniform intensity of 10 cm/hr. If the detention storage on the paved section is increasing at the rate of 60 m3/hr, what is the runoff rate into the inlet grate?

Reference no: EM13210556

Questions Cloud

Why do many managers act like control freaks : What does it have to do with control? Why do many managers act like control freaks? Why do many managers micromanage so much? Why are many managers reluctant to take the actions necessary to correct deviations?
Determine the value of po : determine the value of Po, as a funciton of H, for these two investment alternatives to be equivalent at an interest rate of i=15% per year.
Three underlying dimensions of entrepreneurship : The three underlying dimensions of entrepreneurship. The Nike slogan "Just do it" captures the essense of the meaning of, Innovation as a corporate activity
Create a matlab program and flowchart : Create a MATLAB program and flowchart which will allow the user to input an unknown number of temperatures, each of which might be a temperature in Celsius, Fahrenheit, Kelvin, or Rankine, and will convert the user input temperature to each of the..
What is the runoff rate into the inlet grate : If the detention storage on the paved section is increasing at the rate of 60 m3/hr, what is the runoff rate into the inlet grate?
Challenges faced by manager in terms of communication skills : Discuss the challenges faced by the manager in terms of : Communication skills ,Cultural, Policies or legislations ,Infrastructure , labour laws or any other challanges.
Calculate the force : Calculate the force (in Kn) a punch press must exert if it is to punch out a large washer from a strip of 5-mm thick sheet steel with an ultimate shear strength of 400 MPa. The washer dimensions are as follows: hole diameter is 27 mm. outside diam..
Estimate the volume of soil : A proposed earthen dam will contain 5,000,000 cubic meters of earth. Soil to be taken from a borrow pit will be compacted to a void ratio of 0.78. The void ratio of soil in the borrow pit is 1.12. Estimate the volume of soil (cubic meters) that mu..
Determine the operating speeds of the machine : Determine the operating speeds of the machine at which the machine's steady-state amplitude is less than 0.2 mm. Take keq = 3 EI/L3.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Force required to hold the pipe

A 0.3-m diameter pipeline terminates in a nozzle of outlet diameter = 0.15 m. When water flows through this pipe at a rate of 0.25 m3/s, the force required to hold the pipe (N) is most nearly.

  Length of contracted rectangular weir

A trapezoidal canal 6m wide at the bottom and having a side slope of 1V:2H carries water with a mean velocity of 1.0m/s to a depth of 60cm. What length of contracted rectangular weir 1.0m high should be placed at the middle of the canal to make th..

  Design a single angle strut connected to a gusset plate

Design a single angle strut connected to a gusset plate to carry 180k n factored load. The length of the strut between center to center intersection is 3m.

  Elastic modulus of steel

Given: elastic modulus of steel is 200 GPa, yield and ultimate tensile strength of steel are 600 and 750 MPa, respectively.

  What is effect of packing factor in self compacting concrete

what is effect of packing factor in self compacting concrete?

  Annual power cost of the ro system

Is the system within membrane manufacturer's warranty requirement of maximum flux rate of 14 gfd? What is the annual power cost of the RO system?

  What should be the minimum radius of curvature p

what should be the minimum radius of curvature p for the track at B so that the passengers do not experience a normal force greater than kmg?neglect the size of the car and passengers.Take k=4

  Calculate the detention time

As a consulting engineer you are hired to evaluate the operation and the unit processes within the plant and make recommendations for improvements. You are asked to consider the following units.

  Fraction of the herbicide

The herbicide 2,4,D, is applied to a golf course at a rate of 1.2 kg/ha. The organic matter content of the soil is 1%, bulk density is 1.3 g/cm3, and water content is 0.3. a) What fraction of the herbicide is adsorbed, and what fraction is dissolve..

  Freeways density and level of service

What will the freeway's density and level of service be before and after the ban? (Assume that the trucks are removed and all other traffic attributes are unchanged).

  Highway construction project

A soil sample was taken from a proposed cut area in a highway construction project and sent to a soils laboratory for a compaction test, using the Standard Proctor compaction procedure. Results of the test are as follows:

  Determining specific gravity

The cross sectional dimensions of a 4-ft-long wood member at 30% moisture content is 1.5 in. x 7.5 in., and its weight is 11 lb. At oven-dry condition, its dimensions and weight are 1.35 in x 6.8 in., and 10.2, respectively. What is its specific g..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd