What is the probability that the maximum wind pressure will

Assignment Help Civil Engineering
Reference no: EM13548148

A large parabolic antenna is designed against wind load. During a wind storm, the maximum wind-induced pressure on the antenna, P, is computed as P= 1/2CRV^2 Where C = drag coefficient, R = air mass density in slugs/ft3, V = maximum wind speed in ft/sec, and P = pressure in lb/ft2. C, R, and V are statistically independent lognormal variates with the following respective means and c.o.v’s: mean of c= 1.80 standard deviation= .20 mean of r= 2.3*10^-3 slugs/ft3 standard deviation= .10 mean of v= 120 ft/sec standard deviation= .45

a. Determine the probability distribution of the maximum wind pressure P and evaluate its parameters.

b. What is the probability that the maximum wind pressure will exceed 30 lb/ft2?

c. The actual wind resistance capacity of the antenna is also a lognormal random variable with a amean of 90 lb/ft2 and a c.o.v. of 0.15. Failure in the antenna will occur whenever the maximum applied wind pressure exceeds its wind resistance capacity. During a wind storm, what is the probability of failure of the antenna?

d. If the occurrences of wind storms in (c) constitute a Poisson process with a mean occurrence rate of once every 5 years, what is the probability of failure of the antenna in 25 years?

e. Suppose five antennas were built and installed in a given region. What is the probability that at least two of the five antennas will not fail in 25 years? Assume that failures between antennas are statistically independent.

Reference no: EM13548148

Questions Cloud

Express the approximate alkalinity of this water as mg : A water sample has bucarbonate concentration of 220 mg/l ( HCO3- )and the PH of the water is 7.9 > Express the approximate alkalinityof this water as mg/l of CaCO3
Find all contact forces : Cylinders A & B weigh 500N each and cylinder C weighs 1000N. Assuming frictionless contact between all surfaces, find all contact forces. Diameters A&B= 1, C=2
Calculated the change in vertical effective stress on the : A culvert is to be constructed in a bed of sand (e = 0.5) for drainage purposes. The foof of the culvert will be located 3 m below ground surface. Currently the groundwater level is at ground surface.
Find the z components of the electric field : An electron has an initial velocity with an x component of zero, a y component of 9.35 km/s, a z component 16.1 km/s, and a constant acceleration of 1.60 x 1012 m/s2 in the positive x direction in a region in which uniform
What is the probability that the maximum wind pressure will : A large parabolic antenna is designed against wind load. During a wind storm, the maximum wind-induced pressure on the antenna, P, is computed as P= 1/2CRV^2 Where C = drag coefficient, R = air mass density in slugs/ft3, V = maximum wind speed in ft/..
Determine the stretch of the cord when the system : The two disks each have a mass of 25kg and are attached at their centers by an elastic cord that has a stiffness of k = 1.6kN/m . Determine the stretch of the cord when the system is in equilibrium
Discuss the minimum alignment required to establish the : Explain the process for establishing a centerline for a roadway for an existing road. Include a description of the types of property markers used as well as any problems a surveyor may encounter in this process
Calculate the force in each member of the loaded truss : List the series of steps involved in converting rural land into development. You may refer to an example of local conditions in your reference jurisdiction or you may use a description of such steps that you find from other sources, but do not limit ..
The annual benefits are expected to be constant over : A firm is considering moving its manufacturing plant from Chicago to a new location. The industrial engineering department was asked to identify the various alternatives together with the costs to relocate the plant, and the benefits. The engineers e..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine annual volume of solid waste produce by source

the bailey stone works employs six people. assumming that the density of uncompacted waste is 480 kg/m^3, determine the annual volume of solid waste produce by the stone works assumming a waste generation rate of 1 kg/cap*d.

  The long-term average january precipitation in the colorado

the long-term average january precipitation in the colorado river basin is 1.11 inches with a standard deviation of

  Estimate the combined amounts of water evaporated

An 8000 mile^2 watershed received 20 in. of precipitation in a 1 year period. The annual stream flow was recorded as 5000 cfs. Roughly estimate the combined amounts of water evaporated and transpired.

  Calculate the total vertical stress pore water pressure

An investigation at a particular site reveald 10 m of clay overlying 2m of sand resting on bedrock.the water table was found to be at the ground surface and the piezometric level for the sand to be 2m above ground level

  Calculate its elongation when a load of 100n is applied

consider a cylindrical copper wire 3.0mm in diameter and 3x10^4 mm long. calculate its elongation when a load of 100N is applied. Assume that the deformation is totally elastic and its Young Modulus is 110GPa.

  Calculate the mean velocity of efflux from the nozzle

A smooth nozzle with a tip diameter of 2 inches terminates a 6 in waterline. Calculate the mean velocity of efflux from the nozzle when the velocity in the line is 10 ft/s.

  Determine the critical crack length to assure the plate will

Consider the same plate under the action of cyclic tensile/compressive stresses of 120MPa and -30 MPa, respectively. If the component is to remain safe for 10 million cycles, what is the largest allowable crack length?

  Calculate the maximum mixing height in meters

The atmosphere is stable with a lapse rate of -0.2C/100m. The surface air temperature is 15C. A parcel of air is released at the ground with a temperature of 25C. Calculate the maximum mixing height in meters.

  Find the concrete cross-section and steel area required

Find the concrete cross-section and steel area required for a simply supported rectangular beam with a span of 20 ft that is to carry a computed dead load of 1.3 k/ft and a service live load of 2.25 k/ft.

  What is daily compound rate of interest earned on account

An engineer in a developing country observes that his project bankaccount has grown from 1,600,000 to 1,769,279 (local currencyunits) in 20 days with no deposits or withdrawals being made.

  What is the diameter d of the smallest -size particles

in a hydrometer test , the results are as follows:Gs =2.60 , temperature of water=24c ,and R=43at 60 min after the start of sedimentation . what is the diameter , D, of the smallest -size particles

  What annual volume savings will wastewater achieve

The Pomdeterra wastewater treatment plant produces thickened sludge that has a suspended solids concentration of 3.8 percent. They are investigating a filter press that will yield a solids concentration of 24 percent.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd