List the advantages of compressed natural gas

Assignment Help Civil Engineering
Reference no: EM13535630

1.List the advantages and disadvantages of the following alternative fuels: ethanol, methanol, biodiesel, compressed natural gas, and liquid petroleum gas.

2.In a random city the weak spot of the levee system occurred at flood gates, about 25 feet in wide, 40 feet high, at the end of canals used to pump water from the city into a lake. Higher water level inside the eye, combined with wind results in a “storm surge”. Calculate the force on the levee gates form storm surge 20 feet above level of the lake traveling at about 25 ft/sec.

Reference no: EM13535630

Questions Cloud

What was the hourly rate of temperature change : If the graphs of the functions f(x) and g(x) intersect at the point (–5, –6), then {–5} is the solution to the equation f(x) = g(x).
How long would it take both of them working together : Working by herself, Penny can paint a billboard in 6 hours. Her new apprentice, Brian, requires 12 h to do the same job.  How long would it take both of them working together to paint a billboard?
Calculate the temperature of the fresh concrete : A 1: 1½ : 3 mix (by mass) has a water/cement ratio of 0.4 and a cement content of (400) kg/m3. The temperatures of the ingredients are as follows
Calculate the minimum set-back distance required : Calculate the minimum set-back distance required for a national highway of 4 lane divided carriageway having circular curve of radius of 350 m & design speed 100 km/hr.
List the advantages of compressed natural gas : List the advantages and disadvantages of the following alternative fuels: ethanol, methanol, biodiesel, compressed natural gas, and liquid petroleum gas.
Find the settling velocity of a 20 µm diameter particle with : Find the settling velocity of a 20 µm diameter particle with density 1500 kg/m3. If this particle had been hurled to a height of 8,000 m during a volcanic eruption, estimate the time required to reach the ground
What is the step method for drawing raft foundation : A long line of burning agricultural waste emits 0.3 g/m/s of particulate matter on a clear fall afternoon with winds blowing 3 m/s perpendicular to the line. Estimate the ground-level particulate concentration 400 m downwind from the line.
What must the hydraulic detention time be in the aeration : Although primary and secondary sedimentation is responsible for the removal of some BOD, you will design a bioreactor which removes 85% of BOD entering the plant using an activated sludge bioreactor. Use the following values: Influent (to bioreactor)..
What are alternative treatment option for the removal of edc : What are alternative treatment options for the removal of EDCs in tertiary treatment? Be sure to justify any alternative treatment method you propose.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Magnitudes of fac and fad

The 70 m tall tower is supported by three cables that exert forces FAB, FAC, and FAD on it. The magnitude of the force FAB is 2 kN. The x and z components of the vector sum of the forces exerted on the tower by the three cables are zero. What are ..

  Question 1 a what are minerals sketch different types of

question 1 a what are minerals? sketch different types of mineral crystal forms and list different types of rock

  Determine what is the change in entropy of the water

A piston-cylinder device contains 2 kg saturated water vapor at 600 kPa. The water expands adiabatically until the final pressure is 100kPa. And 1,465 kJ work is produced.

  A car travelling at 60 mph in a construction area skids

a car travelling at 60 mph in a construction area skids into a stack of concrete barriers. skid marks leading to the

  What is the frequency and period of the oscillation

A 780-g mass is attached to a vertical spring and lowered slowly until the mass rests at its equilibrium position 30 cm below the original length of the spring. It is then set into simple harmonic motion of amplitude 5 cm.

  Determine the dimension of this proposed footing

A proposed square footing carrying a total load of 500 kips is to be constructed on a uniform thick deposit of dense cohesionless soil. The soil's unit weight is 135 pcf, and its angle of internal friction is 38 degrees.

  Determine the prism constant

A 100 ft cut steel tape was used to check the layout of a building wall. the rear surveyor held 42 ft while the head surveyor cut 0.33 ft. what is the distance measured?

  Four-lane freeway problem

A four-lane freeway (two lanes in each direction) is on mountainous terrain with 11-ft lanes, a 5-ft right-side shoulder, interchange spacing of one every 10 miles, and a 60-mi/h base free-flow speed.

  How far back from the front axle would the center of gravity

how far back from the front axle would the center of gravity have to be to ensure that the maximum tractive effort developed for front and rear- wheel drive options is equal

  What is the elevation of n held vertically at point m

A transit was set at point M and a leveling rod was held vertically at point N. The horizontal cross line of the telescope was inclined so the reading of the horizontal cross line on the rod was 12 ft.

  Determine the magnitudes of the normal force acting on block

The coefficient of kinetic friction between block A and the inclined plane is mu_k = 0.11 . The angle of the inclined plane is given by theta = 45. Neglect the weight of the rope and pulley. Part A - Normal Force Acting on Block A Determine the ma..

  Which will cause reaction at the bearing to be equal to zero

Determine the magnitude of which will cause the reaction at the bearing to be equal to zero. The bearings are in proper alignment and exert only force reactions on the rod. Set = 600 .

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd