How to select economical solid rectangular timber beam made

Assignment Help Civil Engineering
Reference no: EM13312016

A simply supported beam is to span 12 feet. It will support a uniformly distributed load of 800 pounds per linear foot over the full span and a concentrated load of 1000 pounds acting at 4 feet from the left support. Total deflection is not to exceed span/360. Select an economical solid rectangular (S4S) timber beam made of Southern Pine. Assume the beam weight to be 30 PLF

Reference no: EM13312016

Questions Cloud

Define oxidized to an optically inactive dicarboxylic acid : With aqueous H2CrO4, compound A was oxidized to an optically inactive dicarboxylic acid C, C6H10O4. Give structures for compounds A, B, and C; do not specify stereochemistry
Determine the horizontal force the wire exerts on the poles : A telephone wire 5 mm in diameter is suspended between telephone poles spaced 50 m apart. If the wind velocity is 100 km/h and the air is at 2 degrees C, 1 atm, determine the horizontal force (in N) the wire exerts on the poles.
Explain liquid hcn is unstable with respect to trimer : Liquid HCN is unstable with respect to trimer formation. What would be the structure of this trimer
Write a computer program to calculate deflection at midpoint : Two 52 kN loads are maintained 2.5 m apart as they are moved slowly across beam AB. Write a computer program to calculate the deflection at the midpoint C of the beam for values of x from 0 to 9 m, using .5 m increments.
How to select economical solid rectangular timber beam made : A simply supported beam is to span 12 feet. It will support a uniformly distributed load of 800 pounds per linear foot over the full span and a concentrated load of 1000 pounds acting at 4 feet from the left support.
Explain the enthalpies of bond formation to rationalize : Use the enthalpies of bond formation to rationalize why nitrogen forms a dimer and phosphorous a tetramer.
What is the speed of ambulance : As you stand motionless on the sidewalk, you hear an ambulance siren broadcasting a shrill 610hz sound while it is approaching, What speed is the ambulance
Calculate the total cost using a one-month planning : Calculate the total cost using a one-month planning horizon and calculate the total cost using a three-month planning horizon.
Explain what is the empirical formula of the phosphorus : A 46.2mg sample of phosphorus reacts with selenium to form 135mg of the compound. What is the empirical formula of the phosphorus selenide

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate factor of safety if the material does not yield

The program should use both the maximum shearing-strength criterion and the maximum-distortion-energy criterion. It should also print the values of the principal stresses and, if the material does not yield, calculate the factor of safety.

  Calculate the efficiency rquired of an esp to remove fly ash

a new coal-fired power plant burns 50,000 tons/day of coal with 7% ash and a heating value of 12000 Btu/lbm. Forty percent of the ash drops out of the furnace as slag. Calculate the efficiency rquired of an ESP to remove fly ash

  Determine the coordinates of point e of the lot

Calculate the area of a piece of property bounded by a traverse and circular arc with the following coordinates at angle points: A (1275.11, 1356.11), B (1000.27,1365.70),C (1000.00, 1000.00),D (1450.00, 1000.00)

  What has been the change in internal energy of the gas

A cylinder with a moveable piston holds .20 lb of hydrogen initially in a volume of 1 cu ft at a tem-perature of 1300 F. Then the volume is expanded to 2.5 cu ft while the gas pressure remains constant.

  Determine pressure drop per meter of pipe using moody chart

water flows through a horizontal plastic pipe with a diamter of .2 m at a velocity of 10 cm/s. determine the pressure drop per meter of pipe using the Moody chart.

  What is the pulling force to be applied for one of the plate

Due to temperature change, a 1/32" hole mismatching occurred. What is the pulling force, in lbs, to be applied for one of the plates to match the two holes The plate length is 3 ft (from the left end to the hole) and its cross section is 1/8" x 1"..

  Determine what is one important facet of the system

With all the developments and improvements to the GNSS system over the years, what is one important facet of the system that has not improved

  Determine what is the average velocity of the groundwater

An underground gasoline storage tank has leaked benzene into an unconfined aquifer over a period of several months. The aquifer characteristics are: Ambient temperature=8 oC Hydraulic conductivity = 123 ft/day Hydraulic gradient = 0.00091 ft/ft

  Compute the size of a squeare concrete box culvert to handle

Compute the size of a squeare concrete box culvert to handle a discharge of 25.5 cms. The culvert will have a length of 45.7m with a slope of 0.01 and a maximum headwater depth of 4.57m.

  Hydraulic behaviour in open channel

Describe how test flumes and associated equipment are used to assess and confirm hydraulic behaviour in open channel

  Determine the required pumping rate of the construction

It is required to dewater a construction site 80 m by 80 m. The bottom of the construction will be 1.5 m below the initial water surface elevation of 90 m. Four pumps are to be used in 0.5-m diameter wells at the four corners of the site.

  Determine what is the final specific volume of the system

A closed system of 0.123kg undergoes a frictionless, quasi-static process along the path PV=C from 100kpa to a final state where the volume is twice the initial volume.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd