How many gallons would be required to last the same time

Assignment Help Civil Engineering
Reference no: EM13549256

A water treatment plant effluent is to be disinfected with chlorine from ton cylinders of compressed gas. The plant is 5 million gallons per day. There are a total of 10 useable cylinders in the plant. if the water is chlorinated with a dose of 2 milligrams per liter, how long will the cylinders last until empty? if the gas were to be replaced with liquid sodium hypochlorite (bleach), how many gallons would be required to last the same time as the gas? The sodium hypochlorite solution strength is 15 percent by weight and has the same unit weight as water (specific gravity 1.0). One pound of sodium hypochlorite has the same disinfecting strength as one pound of chlorine gas.

Reference no: EM13549256

Questions Cloud

Determine the torque that develops in the rod : The end of a 0.75-in-diameter rod is fixed to an immovable plate as shown. The length of the rod is 18.0 in. A 50-lb weight is attached to a 16.0-in lever at the end of the Rod so that the weight is hanging perpendicular to the longitudinal axis of t..
The change in length of the cable when the beam is under : A 4-m-long rigid beam is supported by a pinned connection and cable. the beam weighs 2.0 kn and hangs horizontally when unloaded When the beam is not loaded the solid cable is 4.00 m long and has a solid area of 175 mm1
What will the ammonia concentration be 10 miles downstream : The concentration of ammonia is 6 mg/L at one point in the river. If the first – order decay coefficient for the conversion of ammonia to nitrate is 0.05 day-1, what will the ammonia concentration be 10 miles downstream.
What is the normal depth in a 4-foot wide rectangular : What is the normal depth in a 4-foot wide rectangular channel that conveys a discharge of 100 CFS and has a bed slope of 2% with a Manning’s roughness coefficient of 0.025? a).1.3 feet b).2.7 feet c).4.4 feet d).6.2 feet
How many gallons would be required to last the same time : How many gallons would be required to last the same time as the gas? The sodium hypochlorite solution strength is 15 percent by weight and has the same unit weight as water (specific gravity 1.0). One pound of sodium hypochlorite has the same disinfe..
What concentration would correspond to a risk : The drinking water standard for dioxin is 3 x 10-8 mg/L. Using EPA exposure factors for residential consumption, what lifetime risk would this pose? What concentration would correspond to a risk of 10-6? The following data and assumptions apply: Data..
What is the volume of the lake in cubic feet : A shallow lake can be considered a CFSTR. Nitrification, the conversion of ammonia to nitrate (NH3 -> NO3-) occurs in the lake according to first – order kinetics. One stream feeds the lake and one stream empties the lake with the flow rate in both b..
Friction between the floor and the base of the ladder : Modify function random0 so that it can accept 0, 1, or 2 calling arguments. If it has no calling arguments, it should return a single random value. If it has 1 or 2 calling arguments, it should behave as it currently does.
What is the estimated uncertainty in the length of this : The base line vector between the base and roving reciever is 8340m and has an accuracy of +/-(1to 2 cm +/-2ppm). What is the estimated uncertainty in the length of this vector?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate vapor pressure-air pressure and relative humidity

Calculate the vapor pressure, air pressure, relative humidity, and air density at elevation 1500 m if air temperature is 25 degrees C and dew point temperature is 20 degrees C and the lapse rate is 9 degrees C/km

  Draw a footing detail showing all pertinent design parameter

design a square individual footing to support a 16 inch square reinforced concrete column. service loads include a dead load of 180 kips and a live load of 140 kips. both column and footing have fc=3000psi and fy=60000 psi.

  What are the coordinates of the point

An agronomist wants to measure the rainfall at the centroid of a plowed field between two roads. What are the coordinates of the point where the rain gauge should be placed?

  Which of the available soils appears to be most promising

The design engineer desires a soil with a high clay content because it will help keep water out of the landfill. Which of the available soils appears to be most promising? Why?

  Find the magnitude of the force on one side of the plate and

A rectangular plata 5 ft by 4 ft is at an angle of 30 degrees with the horizontal, and the 5-ft side is horizontal. Find the magnitude of the force on one side of the plate and the depth of its center of pressure when the top edge is 1 ft below the w..

  Elevation and stationing of the low point

A 1600 ft long sag verical curve (equal tangent) has a pvc at station 1200+00 and elevation o 1500 ft. the initial grade is -3.5% and the final grade is 6.5%. determine the elevation and stationing of the low point, pvi and pvt.

  Compute the sorbed concentration in equilibrium with the

If the pH of the water is raised to 8.5, what is the equilibrium concentration of the chromium (III) in moles/L? (d) What weight (in pounds) of precipitate is formed if groundwater containing 19,000 mg/L chromium is treated as described in part (c) a..

  What is the absolute pressure at the surface of the mercury

The container is vented to the local atmosphere. What is the absolute pressure at the surface of the mercury and at the bottom of the container. Assume the conditions of the standards atmosphere prevail for pressure. Use sg = 13.54 for the mercury..

  What is discharge revised discharge pressure of compressure

A compressor installed at a whalf (for loading container ships) is able to provide 6 bar.g pressure into the pressure reciever. The compressor is moved to a site that is 5000 ft above sea level (atmospheric pressure 0.85 bar.a

  How many moles of water condense per cubic meter of feed gas

Suppose a sample of the 90 °C air is put in a closed variable-volume chamber containing a mirror, and the pressure is raised at constant temperature until a mist forms on the mirror. At what pressure would the mist form

  Determine the magnitude of the couple which is applied

Three shafts and four gears are used to form a geartrain which will transmit 7.5 kW from the motor at A to a machine tool at F. (Bear- ings for the shafts are omitted from the sketch.) Knowing that the frequency of the motor is 30 Hz

  Determine the largest load p that can be supported

Two wooden members joined by a simple scarf splice and its diagram. The maximum allowable tensile stress in the splice is 75 psi. Determine the largest load P that can be supported and the corresponding shearing stress in the splice.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd