How long will it take for the water to flow out of the 3

Assignment Help Civil Engineering
Reference no: EM13534521

A spherical tank has a circular orifice in its bottom throughwhich the liquid flows out. The flow rate through the holecan be estimated by : Q=C*A*sqrt(2*g*h)

C=orifice coefficient=.55

A=orifice surface area

g=gravitational constant=9.81

h=height of water

How long will it take for the water to flow out of the 3 mdiameter tank with an initial height of 2.75 m. Note that theorifice has a diameter of 3cm

Reference no: EM13534521

Questions Cloud

What would be the concentration of pollutant in the : A lagoon with volume 1500 mg/m3 has been receivingsteady flow of non-conservative waste (reaction rake k = 0.20/day)at a rate of 125 m3/day for a long enough time to assume that steady- state conditions apply. The wasteentering the lagoon has a conce..
Determine the acceleration of each block if someone pushes : Block B rests on a smooth surface. block A is on top of bock B. If the coefficients of static and kinetic friction beween A and B are μ_s=.4 and μ_k=.3, determine the acceleration of each block if someone pushes horizontally on block A with a force a..
Calculate the exact alkalinity : Calculate the exact alkalinity (in mg/L as CaCO3) of a water containing 58.01 mg/L of bicarbonate ion and 160.22 mg/L ofcarbonate ion. The water has a pH of 10.47.
How large must the lagoon be : How much extra water does a 175 - lb concrete canoe displacecompared to an ultra-lightweight 38 - lb Kevlar canoe of the samesize carrying the same load?
How long will it take for the water to flow out of the 3 : How long will it take for the water to flow out of the 3 mdiameter tank with an initial height of 2.75 m. Note that theorifice has a diameter of 3cm
Find the speed of the blocks after block : Block one has a mass of 1.5kg. Block two has a mass of 3.0kg. Treatthe pulleys as hoops. The radius of pulley one is 8.70m. The massof pulley one is 4.5kg.
Relationship between speed and safety in geometric design : A light spring of a constant k=90.0 N/m is attached vertically to atable. A 2.00g balloon is filled with helium (density 0.180 kg/m^3)to a volume of 5.00m^3 and is then connected to the spring, causingit to stretch. Determine the extension distance L..
What will the concentration of megachlor be in four years : Magachlor is present in a lake having a volume of 20,000,000m3 that is used for drinking water. This waterbody can be considered well mixed. Megachlor can beconsidered a conservitive pollutant.
How do you read the moody chart : The P.C. of a 3 degree curve, whose degree is based on a chord of100 ft. arc, is at Sta. 19+39.60 and the P.T is at Sta. 25+64.60. Calculate the deflection angle from the tangent at the P.C to each100-foot station on the curve and to the P.T.

Reviews

Write a Review

Civil Engineering Questions & Answers

  The hypothetical velocity distribution in a horizontal

the hypothetical velocity distribution in a horizontal rectangular open channel is v0.3y msnbspwhere v is the velocity

  Determine groundwater flow per unit width of the aquifer

The piezometer A is located 4,000 ft south of piezometer B.  Approximately 3,000 ft of piezometer B there is a river with an elevation relative to sea level of about 455 ft.

  Determine hydraulic retention time in the treatment system

The BOD5 of the influent wastewater is 150 mg/L and the first-order reaction rate for the degradation of BOD5 is 0.6/hr at 20°C. If the required effluent BOD5 is 20mg/L

  Determine the required diameter of the shaft

The pulleys attached to the shaft are loaded as shown.  If the bearings at A and B exert only horizontal and vertical forces on the shaft, determine the required diameter of the shaft to the nearest 1/8 in. using the maximum-shear-stress theory of fa..

  Find what is the outflow effluent g-loop concentration

A completely mixed continous bioreactor used for growing oenicilin operates at a zero orer system. The input glucose is converted into various organic yeats. the flow rate ti this system is 20 liters per minute and the conversin rate is 4 mg/(min-..

  Determine the rise in liquid level for oil water system

The density of oil is 0.7 g/cc, the density of water is 1.0 g/cc, the radius of capilary is 0.008 cm, the contact angle through water is 58, the interfacial tension is 50 dynes/cm. Calculate the height in cm

  Compute true percent relative error for each approximation

use zero through forth order taylor series expansions to predict f(2.5) for f(x) = ln x using a base point at x=1. compute the true percent relative error for each approximation. discuss the meaning of the results.

  Find the proper diameter pipe to the nearest

You are asked to design a pump station to conveywaste water at a flow rate of 250 cubic meters per hour to anequalization tank. A velocity of at least 3ft/s must be maintained in the pipe to prevent deposition and provide scouring of any previously d..

  Determine the alkalinity and ph of the mixture

Assuming that carbonate species dominate the acid/base behavior of boh solutions and that no gas transfer occurs when they are mixed, determine the alkalinity and pH of the mixture.

  Calculate the speed of the car at the onset of skidding

A car collided with a telephone pole and left 20 ft skid marks on the dry pavement. Based on the damages sustained, an engineer estimated that the speed at collision was 15 mph. If the roadway had a +3% grade, calculate the speed of the car at the..

  Determine what is the most probable length

a line was measured five times, the readings were: 100.08, 100.51, 100.32, 100.16, 100.22. what is the error. What is the most probable length.

  Determine what is the flow depth at the flowrate

A rectangular brickwork channel with width 20 ft laid on a slope 10ft/mi. What is the flow depth if the flowrate is 300vft^3/s

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd