How far does the platform float above the water surface

Assignment Help Civil Engineering
Reference no: EM13539086

A floating platform is supported at each corner by a hollow sealed cylinder 1 m in diameter, the platform itself weighs 25kN in air and each cylinder weighs 1.2kN per meter of length. If the length of each cylinder is 3m how far does the platform float above the water surface, assume specific weight of water =10000N/m^3

Reference no: EM13539086

Questions Cloud

At what rate must 15c makeup water be provided : A 600 MW power plant has an efficiency of 36 percent with 15 percent of the waste heat being released to the atmosphere as stack heat and the other 85 percent taken away in the cooling water. Instead of drawing water from a river, heating it, and ret..
Determine the location of the centroid relative : Design a 2:1 rectangular duct and fan system to pull 40000 scfm of air carrying a medium-density dust through an FCD (Final Control Device) with a ?P of 6.0 in. H2O. Assume the duct system must extend 120-feet and has four 90° elbows.
Calculate the dispersion of the slab : A light beam containing red and violet wavelengths is incident on a slab of quartz at an angle of incidence of 50.7°. Find the dispersion of the slab
Calculate how much energy was dissipated by friction : A 16 kg girl slides down a playground slide that is 2.8 m high. When she reaches the bottom of the slide, her speed is 1.3 m/s. How much energy was dissipated by friction
How far does the platform float above the water surface : A floating platform is supported at each corner by a hollow sealed cylinder 1 m in diameter, the platform itself weighs 25kN in air and each cylinder weighs 1.2kN per meter of length.
What is the rolling resistance of the road : A four-wheel tractor whose operating weight is 47,877 lb is pulled up a road whose slope is +3.5% at a uniform speed. If the average tension in the towing cable is 4,860lb, what is the rolling resistance of the road?
How do you find where maximum gage pressure occurs : Knowing that the tension in cable AD is 405, determine (a) the angle between cable AD and the boom AB, (b) the projection on AB of the force exerted by cable AD at point A.
Determine if the screen needs to be cleaned : A manually cleaned bar screen has bars with a thickness of 8-mm (0.31-in) and openings 25-mm (0.98-in). After operating for a period of time, assume that the opening size decreases
Determine the force p needed to remove the pipe : The segments of pipe and couplings used for drilling an oil well 15,000 ft deep are made of A-36 steel weighing 20 lb/ft. They have an outside diameter of 5.50 in. and an inside diameter of 4.75 in

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the vertical stress at every combination of depth

A circular plate is loaded with a total load of 60 kips distributed uniformly over the surface at a pressure of 100 psi. Calculate the vertical stress at every combination of the following: (a) Depth: 12 and 50 (b) Radial distance from the center ..

  Compute required weight of coarse aggregate per cubic yard

A concrete mix with a 3-inch slump, w/c ratio of 0.50, and sand with a fineness modulus of 2.4 contains 1700 lb/yd^3 of coarse aggregate. Compute the required weight of coarse aggregate per cubic yard.

  How long would it take to reduce h2s concentration

It has been determined experimentally that the reaction follows frst order kinetics with respect to both oxygen andhydrogen sulfide concentrations: d[H2S]/dt =-k[H2S][O2]

  What engineering parameter must the joint surfaces possess

The roadway is to be widened which will require a slope face cut at a steeper angle. Assume zero cohesion along the joints. What engineering parameter must the joint surfaces possess (magnitude) to be stable

  What is the axial force in member hj

The frame shown is used to support high-tension wires. If W = 200 lb, b = 3 ft, a = 30°, what is the axial force in member HJ?

  Determine the worked deeloped in kj per kg of air

air enters a turbine operating at steady state at 8 bar, 1127 C and exits at 1.5 bar, 347 C. The heat transfer from the turbine to its surroundings is 10 kJ/kg of air flowing through the turbine.

  Find what is the future worth at 15 years of the investment

general price inflation is estimated to be 3% for the next 5 years, 5% the 5 years after that, and 8% the following five years. If you invest $10,000 at the market rate of 10% for those 15 years,

  Determine the length of pipe required for coliform

The maximum permissable fecal coliform concentration that may be discharged is 2,000 fecal coliform CFU/L. It is proposed that a pipe carrying the wastewater be used for disinfection process.

  Estimate steady-state radon concentration in the crawl space

The house has a 1 m high dirt-floored crawl space. The emission rate of radon into the crawl space is reported to be 0.6 pCi/m2s. An exhaust system was added to provide 1 air exchange per hour (ACH) in the crawl space. The outdoor concentration of..

  Design and detail the steel reinforcement for the section

a simply supported beam with a span of 8m is to carry, in addition to its weight, a superimposed dead load of 18kN/m and a live load of 30kN/m both over the entire span.

  Determine the power input to drive the compressor

Air enters an adiabatic compressor at 100 kPa and 17 degrees C at a rate of 2.4 m^3/s. It exits at 257 Degrees (C). The compressor has an isentropic efficiency of 84%. Neglecting the changes in kinetic and potential energy

  Determine what fraction of the cyanide is in the cn-form

The sodium cyanide solution ([NaCN]-total = 0.01 M) is kept at pH 10.4. The pH is kept high to keep the cyanide in the CN- form. If CN protonates by the reverse of the HCN dissociation reaction,

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd