Determine the location of the centroid relative

Assignment Help Civil Engineering
Reference no: EM13539089

1.A trapezoidal river channel section has a base dimension of 30 feet, a liquid depth of 4 feet, and side slopes of 4 to 1 (horizontal to vertical).

A) By integration, determine the location of the centroid relative to the channel bottom of this trapezoidal section.

2.Consider a 200ft high, 1200ft wide dam filled to capacity. Determine the hydrostatic force on the dam and the force per unit area of the dam near the top and near the bottom.

3.Design a 2:1 rectangular duct and fan system to pull 40000 scfm of air carrying a medium-density dust through an FCD (Final Control Device) with a ?P of 6.0 in. H2O. Assume the duct system must extend 120-feet and has four 90° elbows.

Reference no: EM13539089

Questions Cloud

Draw the shear and moment diagrams for the girder : The concrete girder supports the two column loads. If the soil pressure under the girder is assumed to be uniform, determine its intensity w and the placement d of the column at B. Draw the shear and moment diagrams for the girder.
How much would her first deposit be in actual dollars : On her 23 birthday, and engineer decides to start saving toward building ip a retirement fund that pays 8% interest compounded quarterly (market interest rate) She feels that 600,000 worth of purchasing power in today's dollars will be adequate
Determine what force must be applied to the plunger : A hypodermic syringe is attached to a needle that has an internal radius of 0.301 mm and a length of 3.01 cm. What force must be applied to the plunger
At what rate must 15c makeup water be provided : A 600 MW power plant has an efficiency of 36 percent with 15 percent of the waste heat being released to the atmosphere as stack heat and the other 85 percent taken away in the cooling water. Instead of drawing water from a river, heating it, and ret..
Determine the location of the centroid relative : Design a 2:1 rectangular duct and fan system to pull 40000 scfm of air carrying a medium-density dust through an FCD (Final Control Device) with a ?P of 6.0 in. H2O. Assume the duct system must extend 120-feet and has four 90° elbows.
Calculate the dispersion of the slab : A light beam containing red and violet wavelengths is incident on a slab of quartz at an angle of incidence of 50.7°. Find the dispersion of the slab
Calculate how much energy was dissipated by friction : A 16 kg girl slides down a playground slide that is 2.8 m high. When she reaches the bottom of the slide, her speed is 1.3 m/s. How much energy was dissipated by friction
How far does the platform float above the water surface : A floating platform is supported at each corner by a hollow sealed cylinder 1 m in diameter, the platform itself weighs 25kN in air and each cylinder weighs 1.2kN per meter of length.
What is the rolling resistance of the road : A four-wheel tractor whose operating weight is 47,877 lb is pulled up a road whose slope is +3.5% at a uniform speed. If the average tension in the towing cable is 4,860lb, what is the rolling resistance of the road?

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is alkalinity of water expressed as mg per l of caco3

A water sample contains 118mg/L of bicarbonate ion, 19mg/L of carbonate ion, and has a pH of 9.5. What is the alkalinity of this water expressed as mg/L of CaCO3

  Discuss the applicability of grouting technology inimproving

Rock masses that donot have the desired properties for a givencivil engineeering application are improved. The method of choicedepends on the purpose for which the rock mass is intended. amongthe common methods for increasing the strength of fissured..

  Find the maximum shearing stress and its location

Find the maximum shearing stress and its location in the shaft and the angle of twist of A with respect to C. Let G = 4x10^6 psi for the entire shaft.

  Determine the required source temperature of heat sink

A Carnot heat engine is supplied with a high temperature heat source at a rate of 200 kW. If the power output of the heat engine is 120 kW, determine the required source temperature if the heat sink temperature is 20 °C.

  Discuss the limitations of the monitoring approach

A passive dosimeter is to be designed for use in obtaining monthly average concentrations of atrazine in a stretch of river. Typical concentrations range from 10 to 50 g/L. Atrazine, a herbicide commonly found in runoff from agricultural lands.

  What is the rolling resistance of the road

A four-wheel tractor whose operating weight is 47,877 lb is pulled up a road whose slope is +3.5% at a uniform speed. If the average tension in the towing cable is 4,860lb, what is the rolling resistance of the road?

  Determine what will be the effect on its biological process

Please let me know whether we can cover these facilities or not and what is micro-biological process in these. If we can provide cover than what will be the effect on its biological process.

  Explain how to calculate axial normal stresses

When a theoretical cutting plane is passed through an axially loaded prismatic bar, perpendicular to the longitudinal axis of the bar, and one side is analyzed as a free-body diagram, there is a uniformly distributed force acting on the bar's cros..

  Superelevation rate for a roadway

What superelevation rate would you recommend for a roadway with a design speed of 100 km/hr and a radius of curvature of 500 m? Assume f = 0.11.

  Find the specific heat capacity of iron at steady state

an iron cube at 400 degrees Celsius is dropped into a insulated bath containing 10kg of water  25 degrees Celsius. the water finally reaches a temperature of 50 degrees Celsius at steady state.

  Determine the location of the hydraulic jump

the flow rate is 600 cfs. for a long distance upstream the bottom slope is 2.5%. the bottom slop of the channel abruptly changes to 0.6% and continues at that slope for a long distance determine the location of the hydraulic jump.

  Dissolved inorganic carbon sample

The total dissolved inorganic carbon (TIC) of a sample of groundwater is 8.33 mM. The temperature of the aquifer is 15C, the pH is 7.5, and the ionic strength is 0.05 M. What is the H2CO3, HCO3-, CO3 2-, and the partial pressure of CO2? [Use activ..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd