Determine the pressure rise in the tire when the air

Reference no: EM13533370

The pressure in a tire depends on the temperature of the air in atire. When the air temp is 25 C, the pressure gage reads 210KPa. If the volume of the tire is 0.025 m3,determine the pressure rise in the tire when the air temperature inthe tire rises to 50 C. Also, determine the amount of air thatmust be bled off to restore pressure to the original value at thistemperature. Assume the atmospheric pressure is 100kPa.

Reference no: EM13533370

Questions Cloud

Four forces act on a small airplane : The slope distance and zenith angle measured from point P to pointQ were 1876.253m and 87.33'24 degrees, respectively. The instrumentand rod target heights were equal. If the elevation of point P is227.965m, above datum, what is the elevation of poin..

How long will it take him to reach the same velocity the : For the free-falling patachutist with linear drag, assume a firstjumper is 70 kg and has a drag coefficient of of 12 kg/s. If a second jumper has a dragcoefficient of 15 kg/s and a mass of 75 kg, how long will it take him to reach the same velocity t..

Provide your code for completing curve fitting : Plot ω vs t, marked by red stars. Label the x-axis, t,and the y-axis, ω. Give the plot a suitable title. Add a legend to the plot describingthe relationship between ω and t. Change the y-axis scale to show the plotfrom estimate ω is -100 to 1100.

Balance the following acid base neutralization reaction : Balance the following acid base neutralization reaction. Identifythe acid and the number of equivalents per mole. Identify the baseand the number of equivalents per mole.

Determine the pressure rise in the tire when the air : The pressure in a tire depends on the temperature of the air in atire. When the air temp is 25 C, the pressure gage reads 210KPa. If the volume of the tire is 0.025 m3

Heat is transferred to the water until the volume quadruples : A piston-cylinder device initially contains 1.4 kg saturatedliquid water at 200 C. Now heat is transferred to the wateruntil the volume quadruples, and the cylinder contains saturatedvapor only

Due to the nature of the waste water : Due to the nature of the waste water, you want to target the high end of this range.Find the proper diameter pipe to the nearest 2" to achieve thisdesign objective.

Determine the maximum depth of water possible without : A 1-m diameter cylindrical mass, M, is connected to a 2-m widerectangular gate. The gate is to open when the water level,h, drops below 2.5 m. Determine the required value forM. Negate friction at the gate hinge and the pulley.

Determine the base of the following arithmetic operation : A distance of 72.55ft. is recorded. A steel tape is supported atthe ends with a tension of 15 lb. and weighting 0.016lb/ft2 . Find the distance corrected for sag.

User Account

All Pages