Determine the change in kinetic energy and the power output

Assignment Help Civil Engineering
Reference no: EM13532250

1.Steam flows steadily through an adiabatic turbine. Theinlet conditions are 10 MPa, 450 C and 80 m/s. and the exitconditions are 10 kPa, 92% quality at 50 m/s. The mass flowrate of the steam is 12 kg/s. Determine the change in kineticenergy and the power output .Steam flows through an adiabatic air.

2.What are the units of specific heat? When undergoing agiven temperature change, which of these two common gasses -air or oxygen – experiences the largest change in its (a)enthalpy, and (b) internal energy.

Reference no: EM13532250

Questions Cloud

Calculate the average velocity of the flow leaving : Water enters a cylindrical tank through two pipes at rates of 250and 100 gal/min. If the level of water in the tank remains constant, calculate the average velocity of the flow leaving thetank through an 8-in. inside-diameter pipe.
Draw a psychrometric diagram labeling the system states : A laboratory space has a heat gain of 3 tons with a sensible heatfactor of 0.7. The indoor design conditions are 78 F at 40% RH. Theoutdoor air design conditions are 95 F at 50% RH. The coolingequipment has a fixed air flow rate of 350 cfm/ton of coo..
Determine the water level in the upstream manhole that would : A circular manhole cover has a weight of 250 N and a diameter of 1meter. Surcharged conditions (this means the sewer is flowing full)have developed in the sanitary sewer
Define your coordinate system : A trapezoid has a bottom width of b, and top width of T, a heightof h, and side slopes of z(horizontal to vertical). By integration, determine the location of the centroid of thetrapezoid Define your coordinate system.
Determine the change in kinetic energy and the power output : Steam flows steadily through an adiabatic turbine. Theinlet conditions are 10 MPa, 450 C and 80 m/s. and the exitconditions are 10 kPa, 92% quality at 50 m/s.
Determine the maximum water hammer pressure if the initial : A 1000ft long steel pipe carries water from areservoir with a water elevation at 826ft. The pipe has a diameterof 12in. with a wall thickness of 0.5in.
Three cylinders from the same mix were tested : Three cylinders from the same mix were tested for strenght.  Cylinders A and B were cast in 4x8 molds while cylinder C was cast in a 6x12 mold.  The total loads were as follows; cylinder A= 65,200 lbs.,  cylinder B= 68,550 lbs., cylinder C= 151,190 l..
What is the stress in the steel the stress in the concrete : A reinforced concrete column has 6 steel rods inserted in the column and the apparatus is subjected to a temperature drop of 90degrees F. from its stress free state.
Determine the total work done on the car by the towing force : Determine the total work done on the car by the towing forcein this distance if the rolling frictional force between the carand the track is 80lb.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the m and o costs for alternative s

Alternative R has a first cost of $100,000, annual M&O costs of $50,000, and a $20,000 salvage value after 5 years. Alternative S has a first cost of $175,000 and a $40,000 salvage value after 5 years

  A dense sand has an effective friction angle of 43 and c0 a

a dense sand has an effective friction angle of 43 and c0. a dry 2.8-inch diameter sample is tested in drained triaxial

  What are the recorded values of r dot and r double dot

at the bottom of a loop in the vertical plane an airplane has a horizontal velocity of 315 mi/h and is speeding up at a rate of of 10ft/s^2. The radius of curvature of the loop is 1mi. The plane is being tracked by radar at O.

  Determine what is the minimum turbulent flow rate

Air at 80oC and a pressure of approximately 1350 kPa abs flows in a 20-mm-diameter tube. What is the minimum turbulent flow rate

  Determine the discharge in the channel in m3 per s

A very long rectangular channel connects two reservoirs and has a longitudinal slope of 0.005. The channel has a width of 10 m and a Manning's n of 0.030.

  How many trucks are required nd what is production of system

On a shovel/truck operation the production of the shovel is 293 BCY/h and a job efficiency of 0.75. The trucks used have a capacity of 12 BCY and have a cycle time of 45 min.(excluding loading).

  Why the share of limestone in austins soils is the same

Soil engineers hypothesize that the share of limestone in Austin's soils is the same as that in San Antonio soils. They take 100 bore holes in each region, with 70 showing limestone in Austin and 60 showing limestone in San Antonio.

  Determine flow on the road and space mean speed

Data obtained from aerial photography showed six vehicles on a 600 ft long section of road. Traffic data collected at the same time indicated an average time headway of 3.6 sec.

  Determine the fine grains of low plasticity

Soil A is micaceous with an average grain relative density of 2.80, and has a high plasticity in its fine fraction. The ground quartz-feldspathic B is, with an average relative density of 2.65 and fine grains of low plasticity.

  Derive equation for the torque in terms including resistance

A movable cone fits inside a stationary conical depression. If a torque is applied to the cone, the cone will rotate at a certain speed depending on the angles θ and β, the radius r o, and the viscosity μ of the liquid.

  Determine what does the e stand for on roads

E on roads extending east and west and S on roads extending north and south.Those roads traveling east and west are designated a number and the letter E.

  How is the spent carbon removed from the pressure contactors

Testing has already been completed on the water and the Usage Rate for the carbon is 0.4 pounds of carbon per 1000 gallons of water treated. The required EBCT is 20 minutes and the carbon longevity must be at least 6 months.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd