Define your coordinate system

Assignment Help Civil Engineering
Reference no: EM13532251

1.A trapezoid has a bottom width of b, and top width of T, a heightof h, and side slopes of z(horizontal to vertical). By integration, determine the location of the centroid of thetrapezoid Define your coordinate system.

2.A 10 cm long cylindrical core sample is subjected to alabrotory flow test under a preaaure differential of 3.4 atm usinga fluid of viscocity 2.5 centipoise (cp). the diameter of thecore is 4cm . a steady flow rate of .35 cm^3/sec wasmeasured. calculate the permeability of this sample.

Reference no: EM13532251

Questions Cloud

Determine the final velocity of each car : The coefficient ofrestitution between each car is 0.8 . Determine the final velocityof each car, after all impacts, assuming (a) cars A and C hit Car Bat the same time, (b) car A hits car B before car C does.
Calculate the average velocity of the flow leaving : Water enters a cylindrical tank through two pipes at rates of 250and 100 gal/min. If the level of water in the tank remains constant, calculate the average velocity of the flow leaving thetank through an 8-in. inside-diameter pipe.
Draw a psychrometric diagram labeling the system states : A laboratory space has a heat gain of 3 tons with a sensible heatfactor of 0.7. The indoor design conditions are 78 F at 40% RH. Theoutdoor air design conditions are 95 F at 50% RH. The coolingequipment has a fixed air flow rate of 350 cfm/ton of coo..
Determine the water level in the upstream manhole that would : A circular manhole cover has a weight of 250 N and a diameter of 1meter. Surcharged conditions (this means the sewer is flowing full)have developed in the sanitary sewer
Define your coordinate system : A trapezoid has a bottom width of b, and top width of T, a heightof h, and side slopes of z(horizontal to vertical). By integration, determine the location of the centroid of thetrapezoid Define your coordinate system.
Determine the change in kinetic energy and the power output : Steam flows steadily through an adiabatic turbine. Theinlet conditions are 10 MPa, 450 C and 80 m/s. and the exitconditions are 10 kPa, 92% quality at 50 m/s.
Determine the maximum water hammer pressure if the initial : A 1000ft long steel pipe carries water from areservoir with a water elevation at 826ft. The pipe has a diameterof 12in. with a wall thickness of 0.5in.
Three cylinders from the same mix were tested : Three cylinders from the same mix were tested for strenght.  Cylinders A and B were cast in 4x8 molds while cylinder C was cast in a 6x12 mold.  The total loads were as follows; cylinder A= 65,200 lbs.,  cylinder B= 68,550 lbs., cylinder C= 151,190 l..
What is the stress in the steel the stress in the concrete : A reinforced concrete column has 6 steel rods inserted in the column and the apparatus is subjected to a temperature drop of 90degrees F. from its stress free state.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the molar fraction of the gas that condenses

The stream from a gas well is a mixture containing 50 mol % methane, 10 mol % ethane, 20 mol % propane, and 20 mol % n-butane. This stream is fed into a partial conderser maintained at a pressure of 250 psia

  What was the probable classification of the soil tested

The specimen was 8 cm in diameter and had a length of 85 mm. The area of the standpipe was 0.45 cm^2. Compute the coefficient of permeability of the soil in cm/s, m/s, and ft/d. What was the probable classification of the soil tested

  What is the discharge rate per unit width of the aquifer

To avoid the salinization of soil in a farming area, parallel drainage canals are to be installed to maintain the water table at a depth of at least 4m below the ground surface. It is thought that no evapo-transpiration would occur below that dept..

  Explain which is 625 feet long connects two bodies of water

A pump is to be used to draw seawater from the bay at an elevation of 0 to a reservoir at a desalination plant that has a water surface elevation of 255 feet. A 12-inch diameter DIP pipe (CHW = 120) which is 625 feet long connects the two bodies ..

  Calculate the volume of gas produced

A 1-kg block of dry ice(solid CO2) becomes a gas at room temperature. calculate the volume of gas produced at 25 degrees celsius and 975 kPa.

  What is flow rate in cfs from the higher to the lower pipe

Water is flowing from a higher to a lower reservoir through a 24-inch pipe that has a Darcy friction factor of 0.02. The local loss coefficients for the bends, entrances, and exits sum to 3.5.

  Find the amplitude-emax of the electric field in focus

A typical energy of a laser pulse from such lasers is 1 mJ. Suppose that energy is uniformly distributed over the laser spot, and the effect is constant during the pulse (a square pulse).

  Determine how the steam is extracted from the turbine

During a regeneration process, some steam is extracted from the turbine and is used to heat the liquid water leaving the pump. This does not seem like a smart thing to do since the extracted steam could produce

  Estimate the total water that will be withdrawn in 2015

Consider a state with a total water withdrawal of 4.5 bgd in 2000. This was distributed as follows: municipal use 1.0 bgd, industrial use 1.5 bgd, and steam electric cooling 2.0 bgd. Assume a 2000 Population of 10 million and a projection of 12 mi..

  Find minimum speed at which train could pass over the tank

find teh minimum speed at which the train could pass over the tank and lift water up to teh full 4 m height. (hint: consider the locomotive to be stationary and neglecting all losses)

  How the gravel will be scoured by the flowing water

The trapezoidal channel has a slope of .004. The sides of the canal are sealed with a plastic membrane, which is protected by a 1 ft thick layer of 1 in diameter gravel. The bottom is a 6 in slab of rough concrete.

  Show process on t-v diagram with respect to saturation line

An insulated rigid tank is initially filled with a saturated liquid-vapor mixture of water. Initially three-quarters of the mass is in the liquid phase, the mass is 10 lbm, and the pressure is 15 psia.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd