Determine the average fluid velocity at the drain port

Assignment Help Civil Engineering

Reference no: EM131310553

An inflatable backyard swimming pool is being filled from a garden hose with a flowrate of 0.12 gal/s.

a. If the pool is 8 ft in diameter, determine the time rate of change of the depth of water in the pool.

b. Suppose that the pool has a drain port with a diameter 0.5 in. Immediately after the drain is opened, the rate of change of the depth of the water in the pool is observed to decrease to 80% of the value calculated in part (a). Determine the average fluid velocity at the drain port.

Reference no: EM131310553

Questions Cloud

One destination address byte : Consider a slotted ring of length 20km with a data rate of 100Mbps and 1000 repeaters, each of which introduces a 1-bit delay. Each slot contains room for one source address byte, one destination address byte, two data bytes and 8 control bits for..

Estimate the test section velocity in miles : An open-circuit wind tunnel draws in sea-level standard air and accelerates it through a contraction into a 1 m-by-1 m test section.

Evaluate the final dissolved oxygen level : If 283 K wastewater, initially containing a dissolved oxygen level of 5×10-3 mmol/L and filling the basin to a depth of 4.55 m, is aerated for 9000 s, evaluate the final dissolved oxygen level.

Create a server diagram to model the physical view of system : To present a static model of the system, create a diagram for a layered architecture view of the system.Using the components you identified in your layered view of the system, create an activity diagram that shows how a customer would place an ord..

Determine the average fluid velocity at the drain port : Suppose that the pool has a drain port with a diameter 0.5 in. Immediately after the drain is opened, the rate of change of the depth of the water in the pool is observed to decrease to 80% of the value calculated in part (a). Determine the averag..

Determine time required to raise initially ozone free water : Determine the time required to raise the initially ozone-free water in the pond to a concentration level of 0.15 mol/m3.

How many bacteria will be present after ten minutes : The bacteria Escherichia Coli are commonly found in the human intestines. How many bacteria will be present after 10 minutes? 20 minutes? 30 minutes? 40 minutes? And 60 minutes?

Calculate the density of the exhaust gas : calculate the density of the exhaust gas. How would your solution to this problem change if the engine were attached to the wing of an airplane flying through still air at a velocity of 900 km/h?

Determine the kla for oxygen for new dispenser : Determine the KLa for oxygen for this new dispenser when it is operated 3.2 m below the liquid surface with the air flow rate of 7:08 × 10-3 m3/s.

User Account

All Pages