Evaluate the final dissolved oxygen level

Assignment Help Physics
Reference no: EM131310555

A 283-m3(10,000 ft3) basin is to be aerated with six spargers, each sparger using air at the rate of 7:08 × 10-3 m2/s. If 283 K wastewater, initially containing a dissolved oxygen level of 5×10-3 mmol/L and filling the basin to a depth of 4.55 m, is aerated for 9000 s, evaluate the final dissolved oxygen level.

The dissolved solids content will be low enough so that Henry's law will be obeyed, with a Henry's law constant of 3:27 × 104 atm/mole fraction.

Reference no: EM131310555

Questions Cloud

Discuss about the watergate scandal : Discuss about The Watergate Scandal.In this exercise you are to write a short paper analyzing the Watergate scandal of the early 1970's. Who was involved and what rank or level did the hold. According to our book, name the type of crime this fall..
What is gas film mass transfer coefficient for tce vapor : What is the gas-film mass-transfer coefficient for TCE vapor in air?- At what position in the bed will the TCE vapor in the air stream reach 90% of its saturated vapor pressure?
One destination address byte : Consider a slotted ring of length 20km with a data rate of 100Mbps and 1000 repeaters, each of which introduces a 1-bit delay. Each slot contains room for one source address byte, one destination address byte, two data bytes and 8 control bits for..
Estimate the test section velocity in miles : An open-circuit wind tunnel draws in sea-level standard air and accelerates it through a contraction into a 1 m-by-1 m test section.
Evaluate the final dissolved oxygen level : If 283 K wastewater, initially containing a dissolved oxygen level of 5×10-3 mmol/L and filling the basin to a depth of 4.55 m, is aerated for 9000 s, evaluate the final dissolved oxygen level.
Create a server diagram to model the physical view of system : To present a static model of the system, create a diagram for a layered architecture view of the system.Using the components you identified in your layered view of the system, create an activity diagram that shows how a customer would place an ord..
Determine the average fluid velocity at the drain port : Suppose that the pool has a drain port with a diameter 0.5 in. Immediately after the drain is opened, the rate of change of the depth of the water in the pool is observed to decrease to 80% of the value calculated in part (a). Determine the averag..
Determine time required to raise initially ozone free water : Determine the time required to raise the initially ozone-free water in the pond to a concentration level of 0.15 mol/m3.
How many bacteria will be present after ten minutes : The bacteria Escherichia Coli are commonly found in the human intestines. How many bacteria will be present after 10 minutes? 20 minutes? 30 minutes? 40 minutes? And 60 minutes?

Reviews

Write a Review

Physics Questions & Answers

  Find the magnitude of the resulting magnetic field

A sphere of radius R is uniformly charged to a total charge of Q. It is made to spin about an axis that passes through its center with an angular speed ω. Find the magnitude of the resulting magnetic field at the center of the sphere.

  Find the equivalent resistance

A resistor is in the shape of a cube, with each side of resistance  R . Find the equivalent resistance between any two of its adjacent corners.

  What is the electric field at the location

Question: Field and force with three charges? What is the electric field at the location of Q1, due to  Q 2 ?

  What is the maximum displacement of the bridge deck

What is the maximum displacement of the bridge deck?

  What is the magnitude of the current in the wire

What is the magnitude of the current in the wire as a function of time?

  Blackbody

Questions on blackbody, Infra-Red Detectors & Optic Lens and Digital Image.

  Gravity conveyor

Illustrate the cause of the components accelerating from rest down the conveyor.

  Calculate the dc voltage

Calculate the dc voltage applied to the circuit.

  Quadrupole moments in the shell model

Quadrupole moments in the shell model

  Determine the tension in each string

Determine the tension in each string

  Introductory mechanics: dynamics

Calculate the smallest coefficient of static friction necessary for mass A to remain stationary.

  Evaluate maximum altitude

Evaluate maximum altitude?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd