Design a non-air-entrained concrete mix for a small job with

Assignment Help Civil Engineering
Reference no: EM13560391

Design a non-air-entrained concrete mix for a small job with a maximum gravel size of 3/4". Show the results as follows:

a. weights of components to produce 5000 lb of concrete.

b. volumes of components to produce 1 yd3 of concrete.

Reference no: EM13560391

Questions Cloud

What is the probability that the vehicle pulling out will : A vehicle pulls out onto a single lane highway that has a flow rate of 280 veh/h (poisson distributed). The driver of the vehicle does not look for oncoming traffic
Apply the concepts and techniques of the module : The purpose of the Final Project is to apply the concepts and techniques of the module to the analysis of real-world situations or problems. You will be expected to use diverse sources of information and to carry out an original analysis rather than ..
Determine the discharge along the gutter and calculate : Someone spills a container of gasoline at the farthest corner of the parking lot during the storm. Estimate the average time for the gasoline to reach the outlet of the gutter.
The situation analysis is essentially a process : The situation analysis is essentially a process of assessing the current situation facing the organisation, arriving at a set of assumptions about the future and identifying key strategic issues that are likely to confront the organisation". Based st..
Design a non-air-entrained concrete mix for a small job with : Design a non-air-entrained concrete mix for a small job with a maximum gravel size of 3/4". Show the results as follows:
Determine the displacement of the beam at each end : A rigid beam (AB), 12 feet in length, with a point load of 9 kips (4 feet from A) is resting on two short steel rods (AC & BD). Diameter of Rod AC is 1 inch, Rod BD diameter is 2 inches. Assuming no buckling in rods, Determine the displacement of the..
What are the strategic aims of the company : What are the strategic aims of the company?
Explaining what corporate social responsibility : Explaining what Corporate Social Responsibility
Determine the minimum horizontal force necessary for 200 lb : Determine the minimum horizontal force necessary for 200 lb man to scale crevice (using his feet and back). The coefficient of static friction between his shoes and his back against the wall is 0.4.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Suggest hen managentment strategy that will maximize profit

Each week a hen can either lay 12 eggs or hatch 4 eggs, but not both. At the end of the four-week period all eggs and chicks will be sold: an egg will bring 10 cents, and a chick will bring 60 cents.

  What do will result if the concentration of the waste

The discharge from the Renenutet sugar beet plant causes the DO at the critical point to fall to 4.0 mg/L. The Meskhenet Stream has a negligible BOD and the initial deficit after the river and wastewater have mixed is zero

  Find what is the composition of the cu-zn-pb alloy

An alloy is made up of 199.4 lbm copper, 204 lbm zinc, and 4.2 lbm lead. What is the composition, in atom percent, of the Cu-Zn-Pb alloy.

  Determine the design speed of the curve

an equal-tangent sag vertical curve is designed with the PVC AT STation 109 + 00 and elevation 950 ft, the PVI at station 110 + 77 and elevation 947.34ft,and the low point at station 110 + 50 . Determine the design speed of the curve.

  Determine what does the equation reduce to in steady flow

Define what each term in the equation means. Overall, what quantity is being conserved? Under what conditions might you be justified in assuming that non-linear terms are not important

  How many gallons would be required to last the same time

How many gallons would be required to last the same time as the gas? The sodium hypochlorite solution strength is 15 percent by weight and has the same unit weight as water (specific gravity 1.0). One pound of sodium hypochlorite has the same disinfe..

  Calculate the total vertical stress pore water pressure

An investigation at a particular site reveald 10 m of clay overlying 2m of sand resting on bedrock.the water table was found to be at the ground surface and the piezometric level for the sand to be 2m above ground level

  The platform is square in plan view and has a cylinder

The floating platform is supported at each corner by a hollow sealed cylinder 1 m in diameter. The platform itself weights 30kN is air, and each cylinder weighs 1.0kN/meter of length. What total cylinder length L

  Determine the curve elements-pc and pt stations

A horizontal curve on a two-lane highway is designed with a degree of curvature of 7 degree and a 50mph design speed. The coefficient of side friction for the design speed is 0.14. Deflection angle is 90 degree.

  How far does a horizontal plane depart from a level surface

The width of a lake is 16 km (it is a flat plane tangent to the radius of the sphere). How far does a horizontal plane depart from a level surface if the earth is a sphere with r=6371km

  Determine current supplied if final temperature is 70 degree

Now 300 kJ of heat is transferred to the refrigerant at constant pressure while 110-V source supplies current to a resistor within the cylinder for 6 min. Determine the current supplied if the final temperature is 70 degrees C.

  Determine wet unit weight and dry unit weight-wet density

Given the following data for an undisturbed soil sample: Gs = 2.69, e = 0.65, water content = 10% Determine wet unit weight and dry unit weight, wet and dry density

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd