Consider the process of baking potatoes in coventional oven

Assignment Help Civil Engineering
Reference no: EM13531117

1.Is it possible for a heat engine to operate without rejecting any waste heat to a low - temperature reservior? Explain.

2.Consider the process of baking potatoes in coventional oven.Can the hot air in the oven be treated as a thermal energyreservoir? Explain

Reference no: EM13531117

Questions Cloud

Determine the required capacity of the motor of the : A step-type escalator as shown is designed to transport 120 persons per minute at a constant speed v=1.5 ft/s. The overall efficiency of the escalator is estimated to be 70%, and a 200% overload is to be allowed. Assuming that the average weight per ..
What is the underflow flow rate : A settling tank in a water treatment plant has an inflow of 2m3/min and a solids concentration of 2100 mg/L. The effluentfrom this settling tank goes to sand filters. Theconcentration of sludge coming out of the bottom (the underflow) is18,000 mg/L, ..
The mass flow rate of the refrigerant and : Refrigerant R-134a enters the evaporator coils placed at the back of the freezer section of a household refrigerator at 120 kPa with a quality of 20 % and leaves at 120 kPa and -20°C. If the compressor consumes 450 W of power and the COP is 1.2
Determine how much money the home owner would have saved : A house that was heated by electric resistance heaters consumed 1200 kWh of electric energy in a winter month. If this house were heated by a heat pump that has an average COP of 2.4, determine how much money the home owner would have saved that mont..
Consider the process of baking potatoes in coventional oven : Consider the process of baking potatoes in coventional oven.Can the hot air in the oven be treated as a thermal energyreservoir? Explain
A subway train is traveling at a speed of 45 mile : A subway train is traveling at a speed of 45 miles/hour whenthe brakes are fully applied on the wheels of cars A and B, causing them to slide on the track
Find the magnitude and direction of the resultant axial : A nozzle that discharges a 4in water jet into the atmosphere is onthe right end of a 10in diameter hose. the water in the pipehas a velocity of 12fps and a gage pressure of 60psi. Find the magnitude and direction of the resultant axial force reaction..
Two crews are to start at opposite ends of a mountain : A standard five-day BOD test is run using a mix consisting of fourparts distilled water and one part wastewater (no seed). Theinitial DO of the mix is 9.0 mg/L, and the DO after five days isdetermined to be 1.0 mg/L. What is BOD5 ?
How many customers would be served pertruck if each home has : Making two runs per day, how many customers would be served pertruck if each home has once-per-week service and the truck is usedfive days per week?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine torque t indicated by a gage reading

A single strain gage is cemented to a solid 4-in diameter steel shaft at an angle B = 25 degrees with a line parallel to the axis of the shaft. Knowing that G = 11.6*10^6 psi

  What do you understand by the term preservation of timber

What do you understand by the term preservation of timber. Briefly explain the different methods of preservation adopted.

  Determine what force was needed to buckle the bar

On a very hot day, I saw a 1.6 meter long steel bar held between two rigid supports that had buckled due to the heat. The bar had a cross section of 10 mm by 40 mm, and I assume was A36 steel.

  What is the change in it internal energy

A gas is compressed at a constant pressure of 0.800 atm from 9.00L tp 2.00L. in the process, 400J of energy leave the gas by heat. (a) What is the work done on the gas? (b) What is the change in it internal energy?

  Determine the consolidation settlement of clay by dividing

The coefficient of volume compressibility is 4x10-4 m2/kN at the ground surface and the reduction in the coefficient of volume compressibility with depth equals depth*0.1*10-4 m2/kN.

  Calculate the work necessary to compress air in cylinder

Calculate the work necessary to compress air in an isolated cylinder from a volume of 6 ft^3 to a volume of 1.2 ft^3. The initial pressure and temperature are 30.0 psia and 50 degree F, respectively.

  Determine the design speed and length of the curve

A horizontal curve is designed for a two-lane road in a mountainous terrain. The following data are known: Deflection angle: 40 degrees Tangent: 436.76 Station of PC: 2695 + 73.89 Side friction factor = 0.12 Superelevation = 8% Superelevation run-off..

  Determine the distance d to the point where skier lands

(a) Determine the distance d to the point where he lands. (b)What are the magnitudes of his components of velocity parallel and perpendicular to the 45 degree surface just before he lands

  What is the benzene concentration at the dwtpat steady state

An industry is illegally dischargingbenzeneinto a river. The concentration in the river atthe point of discharge is 0.2mg/L. A drinking water treatment plant (DWTP) is located 1.5km downstream. The watervelocity in the riveris 0.35km/day.

  Determine what is the drag coefficient at the cars top speed

A 3000-lb car has a maximum speed (at sea level and on a level, paved surface) of 140 mi/h with 16" radius wheels, a gear reduction of 3.5 to 1, and a drivetrain efficiency of 92%. It is know that at the car's top speed the engine is producing 220..

  What the concentration in the effluent be 7 days later

A lagoon with volume 1,200 m3 has been receiving a steady flow of a conservative waste at a rate of 100 m3/day for a long enough time to assume that steady-state conditions apply. The waste entering the lagoon has a concentration of 10 mg/L.

  Is the state water-quality standard being met downstream

If the state standard downstream is not met, the state has informed town 1 that it must treat its sewage further so the downstream standard is met. Use a mass balance approach to show that the state's request is unfeasible.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd