Compute the mass of each product formed

Assignment Help Chemistry
Reference no: EM13274324

Calculate the mass of each product formed when 244 g of silver sulfide reacts with excess hydrochloric acid. Ag2S(s) + HCl(aq) -------> AgCl(s) + H2S(g)

Reference no: EM13274324

Previous Q& A

  Determine the wave equations for all three regions

a) determine the wave equations for all three regions b) what is K for each region c) using matrix algebra, determine the coefficients to the wave eaquation in region 2

  Determine the efficiency when the transformer delivers load

A 3-kVA, 220:110-V, 60-Hz single-phase transformer yields this test data open-circuit test: 200 V, 1.4 A, 50 W short-Circuit test: 4.5 V, 13.64 A, 30 W Determine the efficiency when the transformer delivers a load of 2 kVA at 0.85 power factor laggin..

  The vapor pressure of ethanol and molar heat of vaporization

The vapor pressure of ethanol is 400 mmHg at 63.5 degree celsius. Its molar heat of vaporization is 39.3 kJ/mol. What vapor pressure of ethanol, in mmHg, at 34.9 degree celsius

  Find the density of the solvent

A cylindrical storage tank has a radius of 1.04 m. When filled to a height of 3.64 m, What is the density of the solvent

  Explain how to activate the control of operator

Identify five controls that require the operator to do two destict actions in order to activate the control? EXAMPLE depressing the clutch on a car so that the ignition key will start the car.

  Explain the bitter-tasting compound quinine is a component

The bitter-tasting compound quinine is a component of tonic water and is used as a protection against malaria. It contains only C, H, N and O. When a sample of mass 0.487 g was burned, 1.321 g of carbon dioxide, 0.325 g of water, and 0.0421 g of n..

  Calculate the at-rest earth pressure

Calculate the at-rest earth pressure (po) exerted at the base of the wall and plot the wall pressure diagram and show the location on the wall where the resultant force Po acts.

  Explain the pure compound to do a mixed melting point

You believe your unknown compound is acetanilide that melts at 114-115 degrees, so you ask your professor for a sample of the pure compound to do a mixed melting point. You do the experiment and determine the mixed melting point is 106-110 degrees..

  Find thermal equilibrium values of electron concentrations

(a) the conductivity in a p type silicon semiconductor at T=300 K is sigma=0.25 (ohm-cm)^-1. Determine the thermal equilibrium values of electron and hole concentrations. (b) Repeat part (a) for n type GaAs semiconductor if the resistivity is rho=..

  What conclusion would you reach the sales results are as

A researcher is asked to determine whether or not a productivity objective (in dollars) of better than $75,000 per employee is possible. A productivity test is done involving 20 employees. What conclusion would you reach? The sales results are as fol..

Reviews

Write a Review

 

Similar Q& A

  State how many grams of kno

How many grams of KNO2 must be added to 5.00 liters of 0.67 M HNO2 solution to produce a buffer with pH = 3.15?

  Compute the amount of work that can be obtained

Calculate the amount of work that can be obtained from this reservoir before it cools to the temperature of the cold reservoir which is 0C. Assume that the heat capacity of water is constant over this temperature range at 75 J/(mole*K). Calculate ..

  Find which is the cathode and which is the anode

Consider the reaction of Al and Al+3 and Mg and Mg+2. Which is the cathode and which is the anode

  Whats the hardness of water

You collected a water sample from your shower containing 3.2mM Ca2+ and 1.1 mM Mg2+ whats the hardness of water in terms of CaCO3/L.

  Calculate the cell potential

Calculate the cell potential, , for this galvanic cell and ΔG for the cell reaction at these conditions.

  Explain what is the molarity of a solution made

What is the molarity of a solution made by dissolving 8.56 g of sodium acetate in water and diluting to 750mL?the answer is .139, but how

  What pressure of co would be required for reaction

If you wanted to prepare a solution of CO in water at 25 degrees celsius in which the CO concentration was 2.2 mM, what pressure of CO would

  What percentage of the moles of nacl in this solution

An aqueous solution is 1.00% NaCl by mass. Its density is 1.071 g/mL at 25°C. The observed osmotic pressure of this solution is 7.83 atm at 25°C.

  Explain the pyranose form of fructose is sweeter

the Pyranose form of Fructose is much sweeter than the Furanose form, Sweetness in honey decreases as temperature rises

  Compute the number of moles of acetic acid

Calculate the expected pH of the buffer after the addition of 1.0 mL of 1 M HCl. Remember that you are using 50 ml of the buffer so be sure to calculate the number of moles of acetic acid

  The wavelength of maximum absorbance is solvent dependent

The wavelength of maximum absorbance is solvent dependent. in water, the wavelength of maximum absorbance is 453 nm.

  Calculate the ksp for the compound

the pH of a saturated solution of a metal hydroxide MOH is 9.68. calculate the Ksp for the compound

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd