Compute the concentration of analyte

Assignment Help Chemistry
Reference no: EM13286016

The signal for an instrumental method was measured five times in the presence of an unknown concentration of analyte and yielded the following: 10.2, 11.1, 9.7, 9.2, 10.3 mV.

a) Assuming that the noise is random calculate the signal-to-noise ratio.

b) A calibration curve was prepared from series of standards for various concentrations of this analyte and the line of best fit was determined to be S=1.56C + 0.2, where, S, is the signal in mV and, C, is the concentration in ppm (parts per million). Calculate the concentration of analyte.

c) Estimate the detection limit of this instrumental method based on measurement of the S/N for the unknown.

Reference no: EM13286016

Questions Cloud

Determine what is the depth below the surface : Consider the impurity diffusion of gallium into a silicon wafer. If gallium is diffused into a silicon wafer (with no previous gallium in it) at a temperature of 1100oC for 3h, what is the depth below the surface
What impact will the have on the cellular geometry : show that if n=4, a cell can be split into four smaller cells, each with half the radius and 1/16 of the transmitter power of the original cell. If extensive measurements show that the path loss exponent is three
Compute the concentration of asa in the solution : Measurement of a 4.05x10-4 M ASA standard solution at 275 nm was 0.579. Calculate the concentration of ASA in the solution
Design an arithmetic shifter for the device : When we shift left we fill in the 0's so that a shift of one left gives x1 = 0110 and x2 = 1110. When we shift right we fill with the sign bit, so that a shift of one right gives x1 = 1011 and x2 = 0011 and a shift of two right gives x1 = 1110 and..
Compute the concentration of analyte : A calibration curve was prepared from series of standards for various concentrations of this analyte and the line of best fit was determined to be S=1.56C + 0.2, where, S, is the signal in mV and, C, is the concentration in ppm (parts per million)..
What is the firm dividend : Firm X has a tax rate of 30%. The price of its new preferred stock is $63 and its flotation cost is $3.15. The cost of new preferred stock is 12%. What is the firm's dividend?
Define the concentrations of ch3br and naoh : The following reaction is a single-step, bimolecular reaction: When the concentrations of CH3Br and NaOH are both 0.115 M, the rate of the reaction is 0.0010 M/s.
Design a datapath which inputs three 8-bit unsigned numbers : Design a datapath which inputs three 8-bit unsigned numbers x,y, and z and outputs x - y if x - y > z and outputs x + y otherwise. You may use adders/subtractors, comparators, decoders, and multiplexers in your design
Evaluate the risk of loss and the opportunity for profit : Evaluate the risk of loss and the opportunity for profit when traders buy or sell puts and calls and Evaluate call and put options and describe the differences that a put option and a call option have on interest rates futures.

Reviews

Write a Review

Chemistry Questions & Answers

  Explain zinc acetate in a volumetric flask

In the laboratory you dissolve 15.4 g of zinc acetate in a volumetric flask and add water to a total volume of 500 mL.

  What volume of 0.1000 m naoh is required

What volume of 0.1000 M NaOH is required to titrate a 0.1000 M propionic acid solution, CH3CH2COOH, Ka = 1.3 x 10-5 , to the equivalence point?

  What is the chemical equation that describes

what is the chemical equation that describes both these reactions? Please give the chemical equations of what happens in this situation

  Determine the empirical formula of greenockite

the mineral greenockite is a rare yellow sulfide of cadmium that is 78.0% cadmium and 22.0% sulfur by mass. Determine the empirical formula of greenockite.

  State what is the ph at the equivalence point

What is the pH at the equivalence point when 30.0 mL of 0.20 M HCl are titrated with 0.45 M NaOH at T = 298 K? Kw = 1.00 x 10-14.

  State molecular level that causes the reaction to shift

When heat is added to a solution of CoCl2 and HCl in water, what happens on the molecular level that causes the reaction to shift?

  Explain brominated product of acetanilide is disubstituted

The brominated product of acetanilide is disubstituted aromatic ring( 2 groups on the benzoering)draw any constitutional isomer that has a monosubtituted aromatic ring and the compound should not have any formal charge

  What amount of heat is needed to boil away all of this water

2300 grams of water is heated. If this water starts at a temperature of 17 degrees Celsius, what amount of heat is needed to boil away all of this water?

  What mass of sodium is needed

When sodium reacts with water, 255 mL of hydrogen gas forms along with sodium hydroxide. What mass of sodium is needed for this reaction?

  Explain the total pressure of the atmosphere plus

The buret continues to drain, slowing gradually until coming to a complete stop, as depicted on the right side. At that moment, the total pressure of the gases inside the flask just equals the total pressure of the atmosphere plus the additional p..

  What is the maximum mass of iron

What is the maximum mass of iron, in grams, that can be obtained from 341 g of iron(III) oxide?

  What temperature is it necessary to have twice as many atoms

Find t what temperature is it necessary to have twice as many atoms in the ground state as in the excited state at 16.4 1/cm of c atoms The degeneracy of the ground state is 1 and the first state degeneracy is 3

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd