What does eu do?, Electrical Engineering

Basically,8086 is separated into two part. 1. BIU. 2. EU Execution Unit(EU)Fetch the instruction from Queue(memory(6 byte) in BIU.) and implement it.                

 

 

Posted Date: 4/5/2013 3:51:21 AM | Location : United States







Related Discussions:- What does eu do?, Assignment Help, Ask Question on What does eu do?, Get Answer, Expert's Help, What does eu do? Discussions

Write discussion on What does eu do?
Your posts are moderated
Related Questions
Public safety - Application of Software Defined Radio During emergency situation such as earthquake, tsunami, terrorist attack, public safety officials from different agencies

Q. Explain about For Loop Construct? The loop build causes the for loop to be splitted into portions and portions shared amongst threads in team. The syntax of loop construct

The one line diagram of a simple three-bus power system is shown in the figure below.  Each generator is represented by an emf behind the transient reactance.  All impedances are e

Write a control word for counter 1 of 8253 / 8254 that selects the following options:  load least significant byte only, mode 5 of operation and binary counting.  Then write an ins


Convert number systems from one base to another, and apply the binary number system to logic circuits 1.   Convert the following decimal numbers to binary a.   81 10 b.

1. Find the general solution y(t) of the ordinary di erential equation where ω is a non-negative constant. (Consider the ω = 0 and ω > 0 cases separately). 2. Use Laplac

(a) Average rainfall during the month of January is found to be R mm. A Class A pan evaporation recorded an average of [7 + ( R /100)] mm/day near an irrigation reservoir. The av

Selection of Right- Flex : It is also important that the flex we choose is appropriate to the appliance used. Like fuses, the cables and flexes are also rated according to their

The conditions necessary for sustained oscillation can be summarized as follows: 1. There should be a positive feedback. 2. The loop gain of the circuit must be equal to or g