Stack pointer, Electrical Engineering

Assignment Help:

stack Pointer (SP)

It is also a 16 bit  register and a  memory  pointer similar to  program counter. It holds  the memory  address of the  top of the stack. Stack is a  part of  the memory used to  store  data temporarily  especially  while execution of subroutine.  Data  stored  last is  read  first  in the  stack i e last in first  out ( LIFO).  The use of stack  pointer will be explained in more detail in chapter5.


Related Discussions:- Stack pointer

Explain working of single-phase induction motors, Q. Explain working of Sin...

Q. Explain working of Single-Phase Induction Motors? For reasons of simplicity and cost, a single-phase power supply is universally preferred for fractional-horsepower motors.

Explain isolated i/o scheme, Explain isolated I/O scheme. In I/O mapped...

Explain isolated I/O scheme. In I/O mapped I/O scheme the addresses allocated to memory locations can also be assigned to I/O devices. Because the same address may be assigned

Decrement contents of register - dcr decrement , Decrement  contents of Re...

Decrement  contents of Register The contents of register R will be decremented  by one and  the result is stored  in the same register  R. It is also  an exceptional  case i

What is the need of the resistance used in a clipper, Q. What is the need o...

Q. What is the need of the resistance used in a clipper? Resistor is used in a clipper to limit the current through the diode. To avoid the damage due to excessive current thro

State the advantages of expert systems, State the Advantages of expert syst...

State the Advantages of expert systems -  Never "forgets" to ask a question in determining the logic -  provides consistent answers - Less skilled work force needed, ther

Gas hazards in the laboratory, GAS HAZARDS IN THE LABORATORY : As mentione...

GAS HAZARDS IN THE LABORATORY : As mentioned in the introduction of this unit, the gas hazards in a laboratory arise from LPG and other compressed gases. Though the use of gas for

Short-term measures for technical loss reduction, Short-Term Measures for T...

Short-Term Measures for Technical Loss Reduction The short-term measures involve measures needs for immediate improvement and reduction of losses within the system. These are

Determine voltage and current of single-phase transformer, Q. Three identic...

Q. Three identical single-phase transformers are to be connected to form a three-phase bank rated at 300 MVA, 230:34.5 kV. For the following configurations, determine the voltage,

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd