What are tightly coupled systems, Electrical Engineering

Assignment Help:

What are tightly coupled systems or closely coupled systems?

In a tightly coupled systems the microprocessor (either coprocessor or independent processors) might be share a common clock and bus control logic. The two processors in a closely coupled system might be communicate using a common system bus or common memory.

 


Related Discussions:- What are tightly coupled systems

Determine the form factor and peak factor, Determine the form factor and pe...

Determine the form factor and peak factor: Determine the form factor and peak factor for the above half rectified wave. Solution From the above example, I rms   =

Determine the magnitude of the current, Determine the magnitude of the curr...

Determine the magnitude of the current: For the circuit of Figure below determine the magnitude of the voltage "drops" across each resistor R1 - R7. Determine the magnitude

For sign flag , For Sign Flag  CP ( Call on plus ) CM (Call on minus ...

For Sign Flag  CP ( Call on plus ) CM (Call on minus ) Instruction CP call  the subroutine  from the  specified  memory  location if  sign flag is not set or reset( S=0)

Plc, in industry

in industry

Explain a tube well, Q. Explain a Tube Well? Method of restoring or inc...

Q. Explain a Tube Well? Method of restoring or increasing the capacity of tube well is known as developing a Tube Wells. This is done to eliminate bridging of fine particles on

Gets parameters data display, On running the simulation, a data display wil...

On running the simulation, a data display will automatically open, similar to that shown in figure. The red circle is the source mismatch stability curve. This will give an indicat

Dc generator, Why dummy coil is used in wave winding porpose of dc generato...

Why dummy coil is used in wave winding porpose of dc generator

When input is a triangular wave, Q. When input is a triangular wave. W...

Q. When input is a triangular wave. When the input fed to differentiating circuit is a triangular wave, the output will be a rectangular wave. During the period OA of

MIMO, MIMO downlink mode uses

MIMO downlink mode uses

Find the current and voltage at input terminals of the line, Q. A source of...

Q. A source of impedance ¯ Z S = R S = 100  has an open-circuit voltage v S (t) = 12.5 cos ωot and drives a 75- transmission line terminated with a 75- load. Find the current

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd