Project, Electrical Engineering

Hoe to start?
Posted Date: 3/21/2013 12:37:18 PM | Location : Malaysia







Related Discussions:- Project, Assignment Help, Ask Question on Project, Get Answer, Expert's Help, Project Discussions

Write discussion on Project
Your posts are moderated
Related Questions
The circuit shown below is a DC charging and discharging circuit. a.  At t = 0 sec, switch S1 is thrown to position 1 ("pos1"). Write the mathematical expressions for and .

Two identical three-phase, 33-kV, wye connected, synchronous generators operating in parallel share equally a total load of 12 MW at 0.8 lagging power factor. The synchronous react

Q. Consider the synchronous counter shown in Figure of the text. (a) Draw its timing diagram. (b) Show the implementation of the same synchronous counter using D flip-flops.

Q. In a depletion MOSFET for which V P = 3 V and I DSS = 11mA, the drain current is 3mA when v DS is set at the largest value that will maintain ohmic region operation. Find v G

Simulation of a pn Junction An n + p junction is fabricated on a p-type silicon substrate with N A = 8×10 15 cm -3 . The n+ region has a concentration of N D = 1.5×10 18

What is  the function performed by SIM instruction in 8085? SIM -Set Interrupt Mask. This instruction masks the interrupts as desired .it also sends out serial data by the seri

Holes are majority carriers in (A) P-type semiconductors.  (B) N-type semiconductors. (C)  Insulators.            (D) Superconductors. Ans: Holes are m

File Flops The flip flop is a one storage biteable   device. The basic  bistable device stores a binary  of inputs  value. the flip flops  are categorized according  to the nu

Q. Use the node-voltage method to find the current I through the 5- resistor of the circuit of Figure.

Q. A 5-kVA, 480:120-V, two-winding, 60-Hz, single-phase transformer has an efficiency of 95% while delivering rated load at rated voltage and 0.8 power factor lagging. This transfo