Neural network, Electrical Engineering

solve problem by neural network using matlab code
Posted Date: 12/13/2012 10:54:35 AM | Location : Malaysia







Related Discussions:- Neural network, Assignment Help, Ask Question on Neural network, Get Answer, Expert's Help, Neural network Discussions

Write discussion on Neural network
Your posts are moderated
Related Questions
Q. Basic Characteristics and Operation of MOSFET ? In Figure the gate-to-source voltage is set to zero volts by the direct connection from one terminal to the other, and a volt

Q. Illustrates typical thermal noise waveform? In general, any physical resistor or lossy device can be modeled by a noise source in series with a noiseless resistor, as shown

operation of induction motor

Energy conservation: NEP envisages a voluntary approach initially for promoting energy conservation along with emphasis on labelling of appliances. Gradually as awareness incr

Parallel Operation of Interconnected Synchronous Generators In order to assure continuity of the power supplywithin prescribed limits of frequency and voltage at all the load p

Q. The twin-tee or notch network shown in Figure is often used to obtain band-reject characteristics. (a) Determine the transfer function V 2 /I 1 . (b) Find the angular freq


State about the Embedded Web Technology Embedded Web Technology (EWT) This is a new technology which uses the Internet in real time to interact/control with a device which

Define Time-Shifting Precedes Time-Reversing and Vice Versa Signal x[n] is time-shifted by m samples (delay in time) giving x[n - m]. This signal is then reversed at n = 0 givi

#The requirement is as follows- There is a signal which is in the range of 0 to 5Hz. This signal frequency composition is to determined. The resolution of the determination is 1Hz.