Explain the Methods of solid modeling

The various methods for representing the solids are :

(i)  Half-space method

(ii)  Boundary representation method (b-rep)

(iii)  Constructive solid geometry (CSG or c-rep)

(iv)  Sweep representation

(v)  Analytical solid modeling - ASM

(vi)  Primitive instancing

(vii)  Spatial partitioning representation

 

Posted Date: 7/25/2013 4:05:06 AM | Location : United States

Ask an Expert

Related Discussions:- Explain the methods of solid modeling, Assignment Help, Ask Question on Explain the methods of solid modeling, Get Answer, Expert's Help, Explain the methods of solid modeling Discussions

Write discussion on Explain the methods of solid modeling
Your posts are moderated

Write your message here..

Related Questions

Explain the uses of pier and well foundations, Explain the uses of Pier and... Explain the uses of Pier and Well Foundations Well foundations are used to transmit large loads from piers of bridges and other marine structures. These are constructions carr

Surface development, methods in surface development methods in surface development

Operational Research., define operation research define operation research

Otto cycle - thermodynamics, Ott o Cycle (1876): This cycle consists... Ott o Cycle (1876): This cycle consists of the two reversible adiabatic processes and the two constant volume processes as shown in the figure given below on P - V and T -

Point of contraflexture, how to count point of contraflexture how to count point of contraflexture

Determine period of motion and frequency, (a) Illustrate Fourier Series and... (a) Illustrate Fourier Series and calculate the constant coefficients. (b) A Harmonic motion is provided by x(t) = 10sin(30t -π/3) where t in seconds and phase angle in radians.

Group technology, develop an appropriate group technology coding scheme for... develop an appropriate group technology coding scheme for a line of machine screws using monocode. explain how the coding scheme works. Assume the product line has the following va

Steam hot service insluation thicknesses, Q. Steam Hot Service Insluation T... Q. Steam Hot Service Insluation Thicknesses? Steam Hot Service Insluation Thicknesses are specified based on the following design criteria: Average Annual Climatic Condi

High speed circuit-carburettor in high speed condition , High Speed Circuit... High Speed Circuit : The speed of motorcycle is further increased by raising the throttle valve. In this condition, fuel and air enter through main passage and main jet as can be

What are the different theories of failure under static load, What are the ... What are the different theories of failure under static load, explain briefly? The major theories of failure of a member subjected to bi-axial stress are as below: > Maximu