Electrical drives and actuators, Electrical Engineering

'Electric drives' is a term used to describe DC and AC electric motors that provide continuous rotarmotion. They are often controlled by 'electronic drivesystems' designed to control the commutation, speedand torque output of the motor.

'Electrical Actuators' provide linear or angular displacement (as opposed to continuous rotation) 

Posted Date: 8/27/2012 3:29:50 AM | Location : United States







Related Discussions:- Electrical drives and actuators, Assignment Help, Ask Question on Electrical drives and actuators, Get Answer, Expert's Help, Electrical drives and actuators Discussions

Write discussion on Electrical drives and actuators
Your posts are moderated
Related Questions
Q. Transient behavior of a control system? The transient portion of the time response of a stable control system is that part which goes to zero as time increases and becomes s

Using the approximate equivalent circuit in which the shunt branch is moved to the stator in put terminals, show that the rotor current, torque, and electro magnetic power of a pol

if load is removed so which motor will run fast? series or shunt?

Q.  The armature of 6 -pole dc generator has a wave winding containing 664 conductors. Calculate the generator emf when flux per pole is 0.06 weber and the speed is 250 rpm. At wh

consider a single stage ce amplifier with rs=1kohm,r1=50ohm,r2=2kohm,rc=1kohm,rl=1.2kohm,hfe=50,hie=1.1kohm,hoe=25microamp/volt and hre=2.5*10-4

Two sine waves along with periods of 10 ms and 30 ms are added to generate a single waveform. A spectrum analyzer is utilized to examine the frequency contents of the waveform. Wha

Digital Transmission on Fading Multipath Channels We have discussed thus far digital modulation and demodulation methods for the transmission of information over two types of c

Step Up Chopper In this  chopper average output  voltage  is greater than  input  voltage. The circuit  different  mode  of operation and  current  waveforms are show. When

What is synchronous data transfer? It is a data method which is used when the I/O device and the microprocessor match in speed. To transfer a data to or from the device, the us

Binary  Number Systems As mentioned  earlier this  number is used by  digital  systems like  microprocessor  and other  digital  circuits. This  number  systems  use only two