## dtsi engine, Mechanical Engineering

Assignment Help:
design

#### Find out the average resistance of the ground, Find out the average resista...

Find out the average resistance of the ground: In a construction of pile-driving for building, a pile driver of mass 25 kg freely drops through a height of 3 metre on the top

#### Safety and loss prevention, Q. Safety and Loss Prevention? Are there sp...

Q. Safety and Loss Prevention? Are there special venting requirements for flammables and toxic materials? Air conditioning, heating and ventilation: • are non-sparking fa

#### Feed speed-spindle rpm-cutting time material removal rate, A hole of 25 mm ...

A hole of 25 mm diameter and 62.5 mm depth is to be drilled. The suggested feed is 1.25 mm/rev.and the cutting speed is 60 m/min. Assume the clearance height is 5 mm. Determine: f

#### Service and maintenance procedures, Service and Maintenance Procedures, you...

Service and Maintenance Procedures, you have studied detailed procedure of motorcycle service and maintenance and points to be remembered while servicing. In the next course, you s

#### hammers and mallet-tool and equipment , Hammer/Mallet: Hammer is used to ...

Hammer/Mallet: Hammer is used to strike a job to bring it in shape or otherwise. It is made of carbon steel. The wooden handle does not allow the shock to hand but handles made in

#### Concept and application of limiting friction, Concept and application of li...

Concept and application of limiting friction: Sol.: The maximum value of frictional force that comes into play, when the body just begins to slide over the surface of the ot

#### Illustrate critical damping, Illustrate any three of the following : (i)...

Illustrate any three of the following : (i) Critical Damping (ii) Logarithmic decrement (iii) Vibration Isolation (iv) Equivalent stiffness of spring in series and in p

#### How to calculate coupling factor?, Q. Two coils with self inductances 1H an...

Q. Two coils with self inductances 1H and 4H have a mutual inductance of 1H. The RMS value of current flowing in the two coils is 4A and 1A respectively. Find  the coupling factor

#### Motorcycle repairing, In MOTORCYCLE REPAIRING we have gone through various ...

In MOTORCYCLE REPAIRING we have gone through various complaints related to engine starting, problem related to gear, clutch, etc. and their possible reasons of trouble making. The

#### Time dilation, Time Dilation The measurement of time involves the conce...

Time Dilation The measurement of time involves the concept of clocks attached at each position co-ordinate of a Lorentz frame. As a consequence of Lorentz transformations, it i