Components in a microprocessor, Electrical Engineering

Assignment Help:

What are the basic components in a Microprocessor?

1) Address lines to refer to the address of a block

2) Data lines for data transmit

3) IC chips 4 processing data             

 

 


Related Discussions:- Components in a microprocessor

Determine the current in the circuit and the voltage, Q. Two identical junc...

Q. Two identical junction diodes whose volt-ampere relation is given by Equation in which I S = 0.1 µA, V T = 25 mV, and η = 2, are connected as shown in Figure. Determine the cu

Transistor configurations, TRANSISTOR CONFIGURATIONS: Transistor circu...

TRANSISTOR CONFIGURATIONS: Transistor circuits may be categorized into three configurations based on which terminal is common to both of the input and output of circuit. Th

Define hysteresis, Define Hysteresis Hysteresis is the 'lagging' effect...

Define Hysteresis Hysteresis is the 'lagging' effect of flux density B whenever there are changes in the magnetic field strength H. When an initially unmagnetized ferromagnetic

Write short note on quantization, Q. Write short note on Quantization? ...

Q. Write short note on Quantization? Quantization: This is first step in PCM. Total amplitude range of the modulating signal is divided into a number of standard levels calle

Sr flip-flop, SR FLIP-FLOP (SRFF) The symbol for the SRFF is shown in F...

SR FLIP-FLOP (SRFF) The symbol for the SRFF is shown in Figure (a), in which S stands for "set," R stands for "reset" on the input side, and there are two outputs, the normal o

Explain from the drain characteristics, Q. Explain from the drain character...

Q. Explain from the drain characteristics that a JFET has  infinite resistance? When V GS = 0v when a positive voltage Vds has been applied across the channel and the gate

Sketch the waveforms of sinusoidal voltage source, Q. Consider the op-amp c...

Q. Consider the op-amp circuit of Figure. Sketch the waveforms of v S and v o , if v S is a sinusoidal voltage source with a peak value of 2.

Determine the parameters of the double- revolving-field, Q. The no-load and...

Q. The no-load and blocked-rotor tests conducted on a 110-V, single-phase induction motor yield the following data: • No-load test: input voltage 110 V, input current 3.7 A, and

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd