How many interrupts are there in 8085, Electrical Engineering

Assignment Help:

There are total 12 interrupts in 8085.                       

 

 


Related Discussions:- How many interrupts are there in 8085

General purpose registers, General  Purpose  Registers Registers B, C...

General  Purpose  Registers Registers B, C ,D, E H , and L   are 8 bit  general  purpose  registers. These  registers store  8 bit  data  temporarily  for processing. Some

Determine excitation voltage and power angle, A 500KVA, 6 pole, 500v, 3 pha...

A 500KVA, 6 pole, 500v, 3 phase, wye-connected synchronous generator has a synchronous impedance of 0.1 + j1.5 ohms per phase. If the generator is driven at 1000 r.p.m., what is th

Why the gain of the amplifier decreases if the ce is avoided, Q. Why the ga...

Q. Why the gain of the amplifier decreases if the CE is avoided? When the ce is connected in the circuit, ac signals get bypassed through it to the ground. In the absence of Ce

States ohm''s law, States Ohm's law Ohm's law describes that the curren...

States Ohm's law Ohm's law describes that the current I flowing in a circuit is directly proportional to the applied voltage V and inversely proportional to the resistance R, g

What is the minimum sampling rate, Q. The magnitude spectrum of a continuou...

Q. The magnitude spectrum of a continuous  image is as given below.  a) Sketch the frequency response of the sampled spectrum if   ωs =1.5 ωm along x and 3ωm along  y directions

Calculate the instantaneous and rms values, Q. The flux-density distributio...

Q. The flux-density distribution in the air gap of a 60-Hz, two-pole, salient-pole machine is sinusoidal, having an amplitude of 0.6 T. Calculate the instantaneous and rms value

#linear programming with all three constraints.., #z =x1+2.5x2, with constr...

#z =x1+2.5x2, with constraints, x1+x2>=2, x2 x1+x2 x1=3.question..

Programming languages - introduction to microprocessors , Programming langu...

Programming languages As we  have seen  the evolution of computer  hardware  similarly  programming  languages also  have their  history  of development from  machine  language

Calculate the gain and phase response of fir digital filter, Calculate the ...

Calculate the gain and phase response of an FIR digital filter Calculate the gain and phase response of an FIR digital filter as in below Figure with A 0 = 1, A 1 = 2, A 2 =

Tone used in stronger telephony, Q. Tone used in stronger telephony? Di...

Q. Tone used in stronger telephony? Dial Tone: This tone is used to specify that exchange is ready to accept dialled digits from subscriber. Subscriber must start dialling only

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd