Advantages of gas tungsten arc welding (gtaw), Mechanical Engineering

ADVANTAGES OF GAS TUNGSTEN ARC WELDING (GTAW)

  • Produces high quality, low distortion welds
  • Free from spatter
  • The process can be used with or without filler wire
  • This Can be used with a range of power supplies
  • Welds almost all metals
  • Gives precise control of welding heat
  • The process Allows excellent control of root pass weld penetration.

 


The TIG process is applicable when the highest weld quality is essential. This can be used to weld atmost all types of metals. The operator has good control of heat input and vision is not limited by fumes or smoke from the process.

Posted Date: 9/14/2012 7:30:23 AM | Location : United States







Related Discussions:- Advantages of gas tungsten arc welding (gtaw), Assignment Help, Ask Question on Advantages of gas tungsten arc welding (gtaw), Get Answer, Expert's Help, Advantages of gas tungsten arc welding (gtaw) Discussions

Write discussion on Advantages of gas tungsten arc welding (gtaw)
Your posts are moderated
Related Questions
Transformation Hardening The main features of the laser as a heat source for transformation hardening are: (A) Clean energy source. (B) Energy is localised: no heat spillage.

Types of Friction There are basically two types of friction, (a) Dry Friction    ( b ) Fluid Friction Dry Friction: Dry friction (also called as coulomb friction man

Discover the increase in pressure: A copper tube of 50 mm diameter and 1200 mm length contains a thickness of 1.2 mm along closed ends. This is filled with water at atmospheri

SURFACE HARDENING: In many conditions surface hardening instead of throughout hardening only is enough to serve the reasons. Gears are illustrations. Surface hardening is atta

Explain the Disadvantages of Automation? a) Initial cost is higher providing additional features in machine tools. b) Skilled personnel's are required for maintenance of aut

Compare Petrol engine with Diesel engine with each other ( i ) Basic cycle: Petrol Engine work on Otto cycle whereas Diesel Engine work on diesel cycles. ( i i )

Rope drive: What do you mean by the term rope drive? Sol: The ropes are circular in section. Rope-drive is mostly used when distance between the driving shaft and drive

Two concentric perforared plates are seperated by a 200mm launder and form the flow exit for a clarifier (figure 1). The inlet water flow of 1200 mcubed/hour into the clarifier is

If Low Resistance or Very High Current in Primary Coil Circuit Causes of Problem Remedy Primary ignition coil short circuited

The Specifications for use on a project will be as defined in the ‘Project Execution Plan'. The specification requirements will be clarified in the Engineering Estimate or at the