Find cutting speed for prolonging tool life , Mechanical Engineering

Assignment Help:

Find Cutting Speed for Prolonging Tool Life

A form tool machining at 24 m/minute requires re-sharpening after 30 minutes. What should be the cutting speed for prolonging tool life to 70 minutes n = 0.10.

Solution:

646_Find Cutting Speed for Prolonging Tool Life.png

 

= 22.05 metres/minute


Related Discussions:- Find cutting speed for prolonging tool life

What are interconnecting pipe racks, Q. What are Interconnecting pipe racks...

Q. What are Interconnecting pipe racks? Interconnecting pipe racks carry the main process inlet, export and transfer lines and utility distribution lines to and from process an

Alignment of piping flanges, Q. Alignment of piping flanges? Alignment ...

Q. Alignment of piping flanges? Alignment of piping flanges shall be in accordance with ASME B16.5. This code specifies that: • Flange centerline misalignment must be within

Steam engine main parts, STEAM ENGINE MAIN PARTS:    Connecting Rod: ...

STEAM ENGINE MAIN PARTS:    Connecting Rod: It connects cross head with crank on other side.    Crank Shaft: It is output shaft on which the mechanical power which is a

Files tool and equipment , Files: Files are used to remove excess metal by...

Files: Files are used to remove excess metal by cutting action. These can be classified according to their length, shape, cross-section.

Stresses and strains in bars of varying sections, a concrete column of 350m...

a concrete column of 350mm diameter is reinforced with 4 bars of 25mm diameter . find the stress when the concrete is subjected to a stress of 4.5 MPa . also find the safe load in

Calculate the whole reaction at block, Calculate the whole reaction at bloc...

Calculate the whole reaction at block: A bar weighing 1 kg/m is bent at right angles into segments 0.60 m and 0.30 m long. It takes the position illustrated in Figure, while t

Explain the uses of residual soils, Explain the uses of Residual soils ...

Explain the uses of Residual soils Residual soils may be underlain by sloping rock which may contain weathered seams. The possibility of foundations sliding on these seams have

Determine the change in pressure rise through the compressor, We have a rec...

We have a reciprocating compressor operating at 800 rpm.  Suction pressure and discharge pressure are held constant by other systems that have nothing to do with the compressor.  W

Stress analysis requirements, Q. Stress analysis requirements? All othe...

Q. Stress analysis requirements? All other lines requiring review by the stress group are to be checked for adequate support, stability, excessive movement, etc. Where hand ca

Thermal, Prove that energy is a property of system

Prove that energy is a property of system

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd