Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Fresh water is to be obtained from brackish water at 65°F with a salinity of 0.12 percent on mass basis (or TDS = 1200 ppm). Determine (a) the mole fractions of the water and the salts in the brackish water, (b) the minimum work input required to separate 1 lbm of brackish water completely into pure water and pure salts, and (c) the minimum work input required to obtain 1 lbm of fresh water.
A spring AB of constant k is attached to a support A and to a collar of mass m. The undeformed length of the spring is l. Knowing that the collar is released from rest at x = and neglecting friction between the collar and the horizontal rod, determin..
Blood is flowing through an aorta of 1.0 cm diameter at an average velocity of 50 cm/s. The mean pressure is 100 mm Hg, The blood enters a stenosis where the aortic diameter is 0.5 cm. What is the appropriate pressure at the point of maximum steno..
A lake has a volume of 750,000 m3 (dimensions 15 m deep, 100 m wide, and 500 m long) and behaves as two completly mixed cells. Cell 1 makes up 40% of the lake ( dimensions 15 m deep, 100 m wide, and 200 m long) cell 2 makes up 60% of the lake (dimens..
A trapezoidal channel of bottom width 25ft and side slope 1:2.5 carries a discharge of 450cfs with a normal depth of 3.5 ft. The elevations at the beginning and end of the channel are 685 and 650 ft, respectively.
A solid one-way slab is to be used for a framing system similar to that shown. Column spacing is 33 ft, with regularly spaced beams occurring at 11 ft center to center.
A large steel tower is to be supported by a series of steel wires; it is estimated that the load on each wire will be 19,000N. Determine the minimum required wire diameter assuming a factor of safety 5
A simply supported beam 100 feet in length is pinned at its left end and supported on a roller at its right end. There is a uniformly distributed load of 10 kips/ft along the entire length of the beam. There is also a concentrated load of 20 kips dow..
a 20 mgd wastewater treatment plants primary clarifier influent has 800 mg/l solids. the clarifier removes 18 percent of the solids. the sludge flow rate is 0.070 MGD. (a) what is the solids concentration of primary clarifier sludge
A person with a mass of 200kg wearing snow skis is gliding down a long slope at an angle of 20 degrees. Each ski is 200cm long and 5 cm wide. The pressure of the skis on the snow melts a thin layer of water so that a .1mm layer of water exists under ..
A thermal reservoir (T=308K) is brought in contact with the tank, transferring enough heat to the tank to raise the pressure inside to 4 bar. Calculate the entropy changes of the refrigerant and the thermal reservoir
At 6% interest, how much money is required in the trust fund to provide for the laboratory and equipment and its perpetual operation and equipment replacement?
indicate the conditons by a sketchand determine the difference in the rate of grade at the intersection of each of the following paris of slops.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd