What is the direction of a line of flux, Electrical Engineering

Assignment Help:

What is the Direction of a line of flux

The direction of a line of flux is from the north pole to the south pole on the exterior of the magnet and is then supposed to continue by the magnet back to the point at which it emerged at the north pole. Therefore such lines of flux always form complete closed loops or paths; they never intersect and always have a exact direction. The laws of magnetic attraction and repulsion can be demonstrated by using two bar magnets.

 


Related Discussions:- What is the direction of a line of flux

Equivalent series impedance referred to the high-voltage, Q. A 25-kVA, 2300...

Q. A 25-kVA, 2300:230-V, 60-Hz, single-phase transformer has the following parameters: resistance of high-voltage winding 1.5 , resistance of low-voltage winding 0.015 , leakage

What is the need of the resistance used in a clipper, Q. What is the need o...

Q. What is the need of the resistance used in a clipper? Resistor is used in a clipper to limit the current through the diode. To avoid the damage due to excessive current thro

Find the corresponding change ib in the base current, Q. Using the small-s...

Q. Using the small-signal equivalent circuit of a BJT with gm = 0.03 S, β = 75, and VA = 65 V, a load resistor RL is connected from the collector to the emitter, as shown in Figure

MATLAB, Future scope on MATLAB in India

Future scope on MATLAB in India

Peak inverse voltage - thyristor, Peak inverse Voltage   Peak  inverse v...

Peak inverse Voltage   Peak  inverse voltage is   important parameter in the design of rectifier circuit. PIV is the maximum  voltage that appears across the device  during its

Explain the significance of v number, Explain the significance of V number....

Explain the significance of V number. Ans: V number or V parameter or normalized cutoff frequency is one of the parameter which is used to calculate the maximum number o

Pinch off voltage, Pinch off Voltage: The current in N-JFET because of...

Pinch off Voltage: The current in N-JFET because of a small voltage V DS  is described by: I DSS = (2a) W/L (qN d μ n V DS ) In which 2a  = channel thickness

Electromechanical and electronic switching system, Q. Compare electromechan...

Q. Compare electromechanical switching system with electronic switching system. Sr. No Electromechanical switching System Electroni

Digital modulation, what are the different digital modulation techniques?

what are the different digital modulation techniques?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd