Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Q. Show the Direct connection or one to one topology?
In the one to all topology, there is a path between every node and every other node. The number of paths required is defined by the equation
P = (n2-n)/2,
where n is number of nodes and P, total number of paths.
So number of paths increases considerably as number of nodes increases. Every node should be physically able to connect to paths to every other node so a very large connector and associated interface support circuitry is required at each node. Adding a new node requires major rewiring and affects software which manages communications for the system.
Compare dispersion effects in single mode and multimode fibres? The optical fibres were categorized within two according to the number of modes it passes as: • Single mode fibre
Explain relative data addressing mode (with examples) available in microprocessors. Relative Mode: Operand supplied is an offset, not the actual address. Added the con
Q. What do you mean by Companding? In order to lower the crest factor of a waveform, so as to produce better performance, a process known as companding is used. It works like a
In continuation of Part-B, the student is required to configure an engine management system for the proposed engine and produce a report including the following: A preamble
Q. Draw and explain the working of a negative clamping circuit. The clamping network shown above is a negative clamping circuit that will clamp the input signal to a negative d
Connection of Shunt Capacitors at Distribution Transformer Provision of capacitors at load point is found to be hard in practice because of the additional investments needed.
Introduction: The scheduling system that is followed by the maintenance department is not well established and is dependable on employee's personal judgment. There were a lot o
Switching Characteristics Switching characteristics are also know as dynamic or transient characteristics these characteristics give the information about the time varia
who to write resume for job
Verify the resistance of 1200 m of copper cable having a diameter of 12 mm if the resistivity of copper is 1.7 x 10-8 Ωm
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +91-977-207-8620
Phone: +91-977-207-8620
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd