What is strap footing, Mechanical Engineering

Assignment Help:

What is strap footing?

Strap Footing

You have to use cantilever or strap footings when the proximity of a property line precludes the use of other types for example an isolated column footing may be too large for the area available and the nearest column may be too distant to allow a rectangular or trapezoidal combined footing to be economical. The strap footing may be considered as two individual column footings connected by a strap beam.


Related Discussions:- What is strap footing

About cold extrusion punches, is there any other punch material for making ...

is there any other punch material for making cold forged nut except AISI M2

Give that the reaction between the cup of one sphere, Two similar heavy sph...

Two similar heavy spheres of 50mm radius are in equilibrium within a smooth cup of 150mm radius. Give that the reaction between the cup of one sphere is just double than that betwe

Find speed of dynamo shaft, Find speed of dynamo shaft: Q: W ith the...

Find speed of dynamo shaft: Q: W ith the help of belt an engine running at 200rpm drives line shaft. The Diameter of the pulley on engine is 80cm and the diameter of the pul

Determine for water flow rate, A counter flow heat exchanger is used to coo...

A counter flow heat exchanger is used to cool 2000kg/hr of oil(Cp= 2.5 KJ/Kg K) from 105 o C to 30 o C by the use of water entering at 15 o C. If the overall heat transfer coeff

What are the technical limitations of screw conveyer, What are the Technica...

What are the Technical Limitations of screw conveyer Technical Limitations: ? Turning limitation of this mechanism Actually the Maximum Turning of U-joint is 18° to 2

Evaluate the stresses in the steel and concrete bars, A load of 2MN is appl...

A load of 2MN is applied on a short concrete column 500 mm x 500 mm. The column is reinforced with four steel bars of 10 mm diameter, one in each corner. Evaluate the stresses in t

The leader command-autocad, The Leader Command The Leader command can b...

The Leader Command The Leader command can be used to annotate at any point on a drawing. The command sequence below was used to draw the leader shown in the Figure Below.

Velocity diagram, how do I learn how to present velocity and acceleratio...

how do I learn how to present velocity and acceleration diagram from a free space diagram

Find the component of force on the inclined plane, Find the component of fo...

Find the component of force on the inclined plane: A small block of weight 300N is placed on the inclined plane, which makes an angle 60° with the horizontal. Find the compone

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd