What is programmable interrupt controller, Electrical Engineering

Assignment Help:

What is programmable interrupt controller?

The Programmable interrupt controller is used when several I/O devices transfer datausing interrupt and they are connected to the same  interrupt line of the microprocessor.


Related Discussions:- What is programmable interrupt controller

Calculate the maximum analog output voltage, Q. For the 4-bit D/A converter...

Q. For the 4-bit D/A converter of Figure, calculate: (a) The maximum analog output voltage. (b) The minimum analog output voltage. (c) The smallest detectable analog outpu

Comparison of induction and dielectric heating , Comparison  of Induction ...

Comparison  of Induction and Dielectric Heating After  studying the induction and  dielectric  heating  followings  points  may consider for  comparison  between  induction an

What is meant by blanking, a. Explain the following terms: (6) (i) Persi...

a. Explain the following terms: (6) (i) Persistence of vision (ii) Flicker in motion pictures b. What is meant by blanking? What is the need of blanking pulses? Compare th

Linear and IC applications, bias compensation techniques for ac and dc char...

bias compensation techniques for ac and dc characteristics

Survey process - issues of power supply, Survey Process -  issues of power...

Survey Process -  issues of power supply The steps to be followed in any like survey procedure are given below. There is always a possibility of going back to any previous ste

Dc machine closed-loop dynamics, i) Calculate the eigenvalues of a 100 hp,...

i) Calculate the eigenvalues of a 100 hp, 1150 rpm dc machine at rated flux with no extra load inertia. Use the "hot" value of the armature resistance. Calculate estimates of t

find the maximum power transferred and input resistance, Given: R 1 = R 3...

Given: R 1 = R 3 = 1 k_, R 2 = 100 k_ and k = 0.1 A/V, and step-up transformer turns ratio is 10. a) Find the value of the load resistor RL that would maximize the power

Determine the current and voltage for n-channel jfet, Q. An n-channel JFET ...

Q. An n-channel JFET with A = 300 V, P = 2 V, and I DSS = 10 mA is to be operated in the active mode. Determine i D when v DS = 10 V and v GS =-0.5V.

Block diagram and the truth table of a demultiplexer, Q. Given the block di...

Q. Given the block diagram and the truth table of a demultiplexer, as shown in Figure, obtain its implementation.

Transmission and swiching systems, using a combination of uniselectors and ...

using a combination of uniselectors and two motion selectors, draw a schematic of thousand line exchange and explain its working

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd