Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Q. What is Erosion Loss?
Additional metal thickness must be added in specific locations where metal loss is expected, due to stream flow that is of high velocity, or is abrasive for any reason. Erosion loss usually occurs within a definable area, and compensation can be made as follows:
1. Weld overlay of the area with the intent that the overlay is sacrificial.
2. Addition of a welded wear plate, with the intent that the plate is sacrificial.
Note: Use caution with this method in hydrogen service.
3. Internal refractory linings may be used if appropriate.
The following data was obtained from an orthogonal cutting test : Rake angle = 20o, Depth of cut = 6 mm Feed rate = 025 mm/rev Chip length before cutting = 29.4 mm Chip
Q. Ultrasound Bolt Load Monitoring? Ultrasound measurement of bolt stresses, using ‘Bolt Scope', should be used on: • All bolts tightened by tensioning. • All bolts in hy
State and prove parallelogram law forces
What are the conditions where combined footings used? Two conditions in which it is used are as: a. When an exterior column is immediately adjacent to a property or mechanic
full explaination
Design Standards: The following design standards for a modern airport facility catering to latest models of aircraft may be noted for guidance.
Define density and specific volume. DENSITY (ρ) Density is illustrated as mass per unit volume; Density = mass/ volume; ρ = m/v, kg/m 3 P for Hg = 13.6 × 10 3 kg/m 3
Method:- Using the constant velocity joint attaching to spindle. U-joint is a joint used to attach two non parallel non intersecting shafts, and it can transfer power at angle
Production management: In this Secetion, you have studied the introduction of production management. Functional units in an organization, features of production management and
A composite shaft consists of copper rod of 30mm diameter enclosed in a steel tube of external diameter 50mm and 10 mm thick. The shaft is needed to transmit a shaft is required to
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +91-977-207-8620
Phone: +91-977-207-8620
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd