Estimate the air flow velocity , Mechanical Engineering

Assignment Help:

A smooth glass plate is coated with a special electrically conductive film that may be used to produce a constant heat flux on the plate. Estimate the air flow velocity which must be used to remove 850 W from a 0.5-m-square plate, maintained at an average temperature of 65 0C and dissipating heat to air at 1 atm and 20 0C. Suppose the plate also radiated like black surface to the surrounding 20 0C. what flow velocity would be necessary to dissipate the 850 W under these condition.

                                                                                                                                               

 


Related Discussions:- Estimate the air flow velocity

What are the forces acting on foundations, What are the Forces Acting on Fo...

What are the Forces Acting on Foundations Foundations are normally subjected to vertical loads which are resisted by compressive stress generated in the soil. However, the acti

Measurement of river water levels, Q. Measurement of river water levels? ...

Q. Measurement of river water levels? In designing bridges and other engineering structures on rivers, maximum discharge and highest flood level form essential data for design

POLITICS, WHO IS HOME MINISTER OF INDIA OF 2014?

WHO IS HOME MINISTER OF INDIA OF 2014?

Evaluate the maximum bending stresses, Evaluate the maximum bending stresse...

Evaluate the maximum bending stresses: A beam of I-section illustrated in Figure is simply supported over a span of 10 m. It carries an uniform load of 4 kN/m over the whole s

Insulators-ceramics-refractory and abrasive material, Insulators Therm...

Insulators Thermal insulators are essential in industrial practices, domestic and equipment appliances. That type of materials is basically those that do not have free electro

Scraper launchers and receivers, Q. Scraper Launchers and Receivers? Sc...

Q. Scraper Launchers and Receivers? Scraper launchers and receivers associated with the pipelines shall be located in open, well-ventilated areas with the opening directed away

Find the cycle efficiency, Develop an EES Code for a Rankine cycle with reh...

Develop an EES Code for a Rankine cycle with reheat and with 2 open feedwater heaters.  The cycle is shown below:  Use the following conditions: 1.  700 psi, 850F 2.  500

Find out ratio of upper end area to lower end area of bar, Find out ratio o...

Find out ratio of  upper end area to lower end area  of bar of uniform strength Sol : The figure given to us shows a bar subjected to external tensile load P. If bar had be

Engineering dynamics, engineering dynamics problems of kinetics of particle...

engineering dynamics problems of kinetics of particle

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd