What do you understand by analog to digital conversion, Electrical Engineering

Assignment Help:

Q. What do you understand by Analog to Digital conversion?

What do you understand by A/D conversion? Give an explanation of any one of the following A/D techniques:

(i) Successive approximation.

(ii) Parallel / flash converter.

Ans:

The electronic circuit that translates an analog signal into a digital signal, is called Analog - to - Digital converter (ADC).


Related Discussions:- What do you understand by analog to digital conversion

Calculate the resistance of a 2 km length of aluminium, Calculate the resis...

Calculate the resistance of a 2 km length of aluminium overhead power cable if the cross-sectional area of the cable is 100 mm 2 . Take the resistivity of aluminium to be 0.03x10 -

Calculate the value of the wavelength, In an electron microscope, a beam of...

In an electron microscope, a beam of electrons is produced by a device called an electron gun. In the electron gun, electrons are 'boiled off' from a heated filament (which is the

Find current in bjt, Q. A BJT is biased by the method shown in Figure. If V...

Q. A BJT is biased by the method shown in Figure. If V BEQ = 0.7V, β = 100, V CEQ = 10 V, and I CQ = 5 mA, find I 1 , I 2 , and IEQ.

Current and voltage polarity, why Direct current flow through semiconductor...

why Direct current flow through semiconductors but alternating current cannot flow?

Compare in-channel signalling with common channel signalling, Q. Compare in...

Q. Compare in-channel signalling with common channel signalling? Network wide signalling also involves end to end signalling between originating exchange and the terminating ex

Disconnection of supply, Disconnection of Supply: An Appellate Tribuna...

Disconnection of Supply: An Appellate Tribunal has been created over the Commissions for speedy dispute resolution. It is assumed to adjudicate appeals against orders of the a

Three phase steam turbine generator, A 3 phase 400 volt(line to line) wye c...

A 3 phase 400 volt(line to line) wye connected synchronous motor has Xs= 1 ohm per phase and a negligible armature resistance. The field current is so adjusted that the internal(in

A, A microstrip antenna system operating at 915MHz must be designed using R...

A microstrip antenna system operating at 915MHz must be designed using Rogers RO3010 substrate with the thickness of 0.635mm.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd