What do you mean by feedback in amplification, Electrical Engineering

Assignment Help:

Q. What do you mean by Feedback in amplification?

Feedback :  Feedback in its broadest sense means that a certain amount of the output signal is "fed back" into the input. An amplifier - or an element of an amplifying device - is presented with the input signal, and compares it to a "small scale replica" of the output signal.

If there is any difference, the amp corrects this, and ideally ensures that the output is an exact replica of the input, but with a greater amplitude. Feedback may be as a voltage or current, and has a similar effect in either case.


Related Discussions:- What do you mean by feedback in amplification

Calculate the stator input current, Q. Calculate the stator input current? ...

Q. Calculate the stator input current? The parameters of the equivalent circuit shown in Figure for a three-phase, wye-connected, 220-V, 10-hp, 60-Hz, six-pole induction motor

Draw a relay construction diagram, Draw a relay construction diagram and br...

Draw a relay construction diagram and briefly explain the operation of a relay. Define the terms normally open and normally closed. Define the terms Set and Reset for relays.

Improving joints and connections - energy loss, Improving Joints and Connec...

Improving Joints and Connections - Energy Loss Improper joints are a source of energy loss in both overhead and underground systems. The conductivity of joint should not be le

Comparison of rs232c and rs422a standards, Explain explanatory notes on com...

Explain explanatory notes on comparison of RS232C and RS422A standards. Comparison of RS232C and RS422A standards: RS232C 1. Standard explained for asynchronous commu

Digital electronics, Design a recycling MOD 19 up counter using JK FFs. In ...

Design a recycling MOD 19 up counter using JK FFs. In your design, include the logic circuit diagram and the timing diagram output that counts from 000002 = 010 to 100112 = 1910. C

high frequency electronic ballast - power supplies , Normal 0 ...

Normal 0 false false false EN-IN X-NONE X-NONE   High Frequency   Electronic Ballast

When input is a triangular wave, Q. When input is a triangular wave. W...

Q. When input is a triangular wave. When the input fed to differentiating circuit is a triangular wave, the output will be a rectangular wave. During the period OA of

Cro, explain the operation of a detector probe

explain the operation of a detector probe

Dynamic response of control systems, Q. Dynamic Response of Control Systems...

Q. Dynamic Response of Control Systems? The existence of transients (and associated oscillations) is a characteristic of systems that possess energy-storage elements and that a

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd